Push 39
Product: Push Cordless drill
Push, Genemuiden, The Netherlands
Sound pressure level < 75 dB(A)
Vibration (
-
a
w
) < 2.5 m/s
2
Cordless drills are supplied with
batteries. If the batteries can no
longer be charged, do not throw
them away but hand them in to the
domestic chemical waste depot.
SERIAL NUMBER
The serial number on the machine consists of the follo-
wing elements..
Serial nr.
CAREFULLY READ THE INSTRUCTIONS
BEFORE YOU USE THE CORDLESS DRILL!
SPECIAL SAFETY RULES
1. Check that:
- the voltage of the charger corresponds to the
mains voltage. Chargers with an indicated vol-
tage of 220V are also suitable for 230V;
- the cord and the mains plug are in good condi-
tion: not damaged or frayed;
- the secondary voltage of the charger corres-
ponds to the charging voltage of the battery
charger and the supply voltage of the battery;
- the voltage of the battery corresponds to the
supply voltage of the rechargeable drill.
2. Never use a long extension cord with the charger.
3. Immediately switch off the machine when the drill
bit gets stuck during drilling.
4. Always make sure the maximum allowed speed for
accessories is suitable for the speed of the drill.
5. Never tie the chuck key to the drill with a piece of
rope or something simular, but store the key in the
special holder on the top of the machine.
6. Never use the battery charger to charge other bat-
teries than the battery provided with the drill.
7. Never attempt to open the housing of the battery
pack. Do not incinerate the battery pack as this can
release very dangerous chemicals or cause the bat-
tery pack to explode.
8. Do not use the battery charger or the adapter in
damp or wet conditions.
WHEN USING THE MACHINE:
1. Always switch off the machine before moving it
downward alongside your body.
Never use the reverse switch during drilling!
IMMEDIATELY SWITCH OFF THE
MACHINE WHEN:
1. There is a failure in the battery or the battery con-
nections.
2. The switch is defective.
3. Insulation material starts to smoke or smell.
BEFORE USE
1. Use only sharp drill bits that are right for the job:
METAL HSS:
WOOD HSS:
2. Drill or screwdriver bits can easily be mounted in
the drill chuck without a chuck key. Firmly tighten
the drill chuck by hand.
3. Place the battery in the grip handle of the recharge-
able drill. There is only one way to install the bat-
tery correctly.
ORDER NUMBER/YEAR OF COSTRUCTION