604323
84
Verklein
Vergroot
Pagina terug
1/86
Pagina verder
9.3x Low-Impact Treadmills Assembly Guide 8
Checking the Alignment and Adjusting the Running Belt
Proper belt alignment allows the belt to remain centered and ensures
smooth operation. Realigning the belt takes a few simple adjustments. If you
are unsure about this procedure, call Precor Customer Support. Refer to
Obtaining Service.
To check the alignment:
CAUTION: Special care must be taken when aligning the running belt. Turn Off
the treadmill while adjusting or working near the rear roller. Remove any
loose clothing and tie back your hair. Be very careful to keep your fingers and
any other object clear of the belt and rollers, especially in front of the roller
and behind the deck. The treadmill will not stop immediately if an object
becomes caught in the belt or rollers.
1. The treadmill has adjustable rear feet. Make sure that the running surface is
level before aligning or adjusting the running belt. Refer to step 18.
2. Connect the power plug to an appropriate dedicated circuit and turn the
unit On.
3. Stand beside the treadmill and press QUICKSTART.
4. If needed, enter the password. Refer to your owner’s manual. The running belt
starts automatically after a 3-second countdown appears on the display.
5. Press the SPEED up arrow key until the display shows a speed of 3 mph
(5 kph).
CAUTION: If you hear any chafing or see that the running belt appears to
be getting damaged, stop the running belt immediately by pressing the
red STOP button. Contact Precor Customer Support.
6. Walk around to the rear of the unit and observe the belt for a few minutes. The
belt should run centered along the running bed. If the belt drifts off center, you
will need to make adjustments. Refer to the next section.
Important: If the belt needs alignment, make the adjustments at once. Failure
to align the belt may cause the belt to tear or fray, which is not covered by the
Precor Limited Warranty.
7. To stop the running belt, press the red STOP button.
8. Turn the treadmill Off.
To adjust the running belt:
If you are unsure about adjusting the running belt, contact Precor Customer
Support. Refer to Obtaining Service.
CAUTION: For your safety, use the power switch to turn Off the treadmill
before making any adjustments. Do not adjust the running belt when
someone is standing on the unit.
1. Locate the right belt adjustment bolt in the rear end cap of the treadmill.
To determine left and right, stand at the rear of the treadmill and face the
display. Make all belt adjustments on the right rear corner bolt using the
¼-inch hex key.
If the belt is off center to the LEFT, turn the adjusting bolt ¼ turn
counterclockwise, which moves the running belt to the right.
If the belt is off center to the RIGHT, turn the bolt ¼ turn clockwise, which
moves the belt to the left.
Important: Do not turn the adjusting bolt more than ¼ turn at a time.
Overtightening the bolt can damage the treadmill.
2. Recheck the alignment of the running belt.
Adjustment bolt location
84

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Precor 9.31 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Precor 9.31 in de taal/talen: Engels als bijlage per email.

De handleiding is 6,39 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info