481032
13
Verklein
Vergroot
Pagina terug
1/17
Pagina verder
POWXQG7556 EN
Copyright © 2015 VARO P a g e | 13 www.varo.com
Be sure to carefully balance blade after sharpening. The blade can be tested for balance by
balancing it on a round shaft screwdriver. Remove metal from the heavy side until it balances
evenly.
Before reassembling the blade and the blade adapter to the unit, lubricate the engine
crankshaft and the inner surface of the blade adapter with light oil. Install the blade adapter on
the crankshaft with the "star" away from the engine. Refer to figure 15. Place the blade with
the part number facing away from the adapter. Align the washer over the blade and insert the
hex bolt. Tighten the hex bolt to the torque listed below:
9.3.3 Blade mounting torque
Centre Bolt 40 Nm-50 Nm, to insure safe operation of your unit. ALL nuts and bolts must be
checked periodically for correct tightness.
After prolonged use, especially in sandy soil conditions, the blade will become worn and lose
some of the original shape. Cutting efficiently will be reduced and the blade should be
replaced. Replace with an approved factory replacement blade only. Possible damage
resulting from blade unbalance condition is not the responsibility of the manufacturer.
When you change the blade you must use the original type marked on the blade.
10 STORAGE INSTRUCTIONS (OFF SEASON)
The following steps should be taken to prepare lawn mower for storage.
1. Empty the tank after the last mowing of the season.
Empty the petrol tank with a suction pump.
Caution! Do not drain the petrol in closed rooms, in close proximity of open
fire, etc. Do not smoke! Petrol fumes can cause explosion or fire.
Start the engine and let it run until it has used up all remaining petrol and stalls.
Remove the spark plug. Use an oilcan to fill approx. 20 ml oil into the combustion
chamber. Operate the starter to evenly distribute the oil in the combustion chamber.
Replace the spark plug.
2. Clean and grease the lawnmower carefully as described above under “Lubrication”.
3. Slightly grease the cutter to avoid corrosion.
4. Store the lawnmower in a dry, clean and frost-protected place, out of reach of
unauthorized persons.
Caution! The engine must have completely cooled down before storing the
lawnmower.
NOTE:
When storing any type of power equipment in an unventilated or material storage shed,
care should be taken to rust-proof the equipment. Using a light oil or silicone, coat the
equipment, especially cables and all moving parts.
Be careful not to bend or kink cables.
If the starter rope becomes disconnected from rope guide on handle, disconnect and
ground the spark plug wire, Depress the blade control handle and pull the starter rope out
from engine slowly. Slip the starter rope into the rope guide bolt on handle.
11 TRANSPORT
Turn the engine off. Ensure not to bend or damage the cutter when pushing the lawnmower
over obstacles.
13

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Powerplus-POWXQG7556

Zoeken resetten

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Powerplus POWXQG7556 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Powerplus POWXQG7556 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,42 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Powerplus POWXQG7556

Powerplus POWXQG7556 Gebruiksaanwijzing - Nederlands - 18 pagina's

Powerplus POWXQG7556 Gebruiksaanwijzing - Nederlands - 21 pagina's

Powerplus POWXQG7556 Gebruiksaanwijzing - Deutsch - 19 pagina's

Powerplus POWXQG7556 Gebruiksaanwijzing - Français - 18 pagina's

Powerplus POWXQG7556 Aanvulling / aanpassing - Alle talen - 7 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info