POWXG7217 EN
Copyright © 2020 VARO NV P a g e | 6 www.varo.com
▪ Be very careful when changing the direction of the cultivator on a slope.
▪ Do not use the cultivator on a slope of more than 10°. The maximum angle for safe
working (as shown) is for reference purposes only and should be determined according to
the type of tool.
▪ Before starting the engine, check that the cultivator is not damaged and is in good
condition. For your safety and the safety of others, exercise extreme care when using the
cultivator up or down a hill.
6 PETROL SAFETY WARNINGS
WARNING: Use extra care in handling fuels. They are inflammable and the
vapours are explosive. The following points must be observed.
▪ Use only an approved container.
▪ Never remove the fuel cap or add fuel with the power source running. Allow engine
exhaust components to cool before refueling.
▪ Do not smoke.
▪ Never refuel the machine indoors.
▪ Never store the machine or fuel containers inside where there is an open flame, such as a
water heater.
▪ If fuel is spilled, do not attempt to start the power source, but move the machine away
from the area of spillage before starting.
▪ Always replace and securely tighten the fuel cap after refueling.
▪ If the tank is drained, this should be done outdoors.
7 ASSEMBLY INSTRUCTIONS
See separate booklet.
8 CONTROLS
8.1 Fuel valve lever
▪ The fuel valve lever must be in the ‘ON’ position when starting the engine.
▪ When the engine is not in use, leave the fuel valve lever in the ‘OFF’ position
8.2 Choke lever
▪ When starting cool engine, turn choke lever to “ ” position.
▪ When starting warm engine and operating, turn chock lever to “ ”position.
8.3 Throttle lever
The throttle lever controls the engine speed.
Putting the throttle lever on position can make the engine run faster and switching to
can make the engine run slower. By switching to , engine will stop.
