POWXG7214 EN
Copyright © 2019 VARO NV P a g e | 6 www.varo.com
5.1.6 Operation on slope
▪ When tilling on slopes, keep the fuel tank less than half full to minimize fuel spillage.
▪ Till across the slope (at equally spaced intervals) rather than up and down it.
▪ Be very careful when changing the direction of the cultivator on a slope.
▪ Do not use the cultivator on a slope of more than 10°. The maximum angle for safe
working (as shown) is for reference purposes only and should be determined according to
the type of tool.
▪ Before starting the engine, check that the cultivator is not damaged and is in good
condition. For your safety and the safety of others, exercise extreme care when using the
cultivator up or down a hill.
6 PETROL SAFETY WARNINGS
WARNING: Use extra care in handling fuels. They are inflammable and the
vapours are explosive. The following points must be observed.
▪ Use only an approved container.
▪ Never remove the fuel cap or add fuel with the power source running. Allow engine
exhaust components to cool before refueling.
▪ Do not smoke.
▪ Never refuel the machine indoors.
▪ Never store the machine or fuel containers inside where there is an open flame, such as a
water heater.
▪ If fuel is spilled, do not attempt to start the power source, but move the machine away
from the area of spillage before starting.
▪ Always replace and securely tighten the fuel cap after refueling.
▪ If the tank is drained, this should be done outdoors.
7 ASSEMBLY INSTRUCTIONS
7.1 Blade assembly
▪ Connect the right blade assembly (Fig. 2A-2D)
▪ Fix the blade assembly with the bolt and fix pin (Fig. 2E-2G)
▪ Assemble the left blade in the same way
7.2 Protective plate assembly
▪ Insert the protective plate into the blade assembly and fix it with the bolt and the pin (Fig.
3A-3D)
▪ Assemble the right plate in the same way
▪ Insert the blade assembly into the transmission shaft with the bolt and fix pin (Fig 3E-3I)
7.3 Depth regulator assembly
▪ Loosen the locking knob and then remove the depth regulator from the machine (Fig. 4A)
▪ Insert the depth regulator into the hole of the machine from bottom to top as shown (Fig.
4B)
▪ Tigthen the locking knob (Fig. 4C)
7.4 Adjusting the depth regulator
▪ Loosen the locking knob
▪ Align the hole on the regulator and adjust the depth.
▪ Lock the knob