POWXG50400 EN
Copyright © 2020 VARO P a g e | 6 www.varo.com
Keep away from ignition sources and open flames, handle outdoors only in
a well ventilated area.
DO NOT smoke and wipe up any spills immediately.
ALWAYS shut off the engine and allow to cool BEFORE fueling.
NEVER add fuel to a running or hot machine.
ALWAYS refuel in a well ventilated area, away from buildings or sources of
ignition. Move at least 30 feet from the refuelling area before starting the
machine.
NEVER operate the machine without the fuel cap.
Failure to safely handle fuel could result in serious personal injury.
▪ Place the machine on a flat, level surface and remove the fuel filler cap (1).
▪ Carefully pour petrol into the fuel tank.
NOTE: This is a 4 stroke machine so DO NOT mix fuel with oil.
▪ Leave a 25mm gap between the fuel and the top of the fuel tank.
▪ Replace the fuel filler cap and tighten securely.
▪ Wipe up any spills immediately.
10 STARTING PROCEDURE
WARNING! This machine is shipped without oil and fuel. You MUST ensure
all fluid levels are correct before operation otherwise you may cause serious
engine damage that will not be covered by the warranty.
10.1 From cold
▪ Place the machine on a flat level surface.
▪ Turn the engine switch to the ‘I’ position (ON).
▪ Slowly press the primer bulb 5 to 10 times. (2)
NOTE: After the 7th press, fuel should be visible in the primer bulb. If it is not,
continue to press the primer bulb until you see fuel in the bulb.
▪ Push the choke button (3) in, to set the choke to FULL CHOKE position.
NOTE: Do not squeeze the throttle trigger because the choke will pop out
automatically.
▪ Pull the recoil starter handle (12) until you feel resistance. Once you feel resistance, pull
the recoil starter handle swiftly 3 to 5 times or until you hear the engine turn over or begin
to start.