7.5 Special holder for stone drilling / milling (Fig. 6, 7, 8, 9, 10 & 11)
▪ Remove the ring by turning it anticlockwise.
▪ Insert the drill or the milling piece (not included).
▪ Screw the milling piece on the machine.
▪ The working depth of the accessory can be set by unscrewing the wing nut. Move the
milling piece forward and backward in order to determine the desired setting. Then fix the
wing nut again.
▪ When the scale of the milling piece has been set to 20 and the tip of the drill or milling
piece protrudes exactly 20 mm out of the special holder, the scale can be used for setting
the correct working depth.
▪ If starting in the middle of the work piece is required (hole or groove as a starting point),
place the machine with the milling piece inclined to the working piece, so that the tip of the
piece is directed to the starting point. Then switch the machine on, direct it to the work
piece and tilt it slowly, until the machine is pointing vertically to the working piece.
7.6 Vice with support an flexible shaft (Fig. 12, 13, 14, 15, 16 & 17)
▪ Having mounted the vice with support on a work bench, the multi tool can be hanged up
by means of the bracket on the handle.
▪ The flexible shaft enables the modified machine to reach places which cannot be
accessed with the standard version of the multi tool.
▪ Mount the support as shown in the picture. The height of the tripod can be adjusted by
means of the telescopic tube. Fix the desired position by turning the tube.
▪ Remove the ring from the multi tool and store it in a safe place.
▪ Pull out the internal drive shaft of the flexible shaft and insert it into the collet chuck.
