POWX1280 EN
Copyright © 2022 VARO P a g e | 9 www.varo.com
▪ Release the spindle lock collar (9).
8.4 Using the bits and tools (Fig. B)
Attention! Before performing any work on the equipment, pull the
power plug.
Do not use the tool on light metal with a magnesium content exceeding 80%,
as this type of metal is flammable.
Always test any bit or tool on a scrap piece or invisible part of the working
material to avoid damage to the workpiece.
8.4.1 Grinding bits (J & K)
Use: Sharpening, deburring, rust removal, shaping.
Tip: Clean and shape the grinding bits with the honing stone (H).
8.4.2 Grinding points (I)
Use: For fine engraving of various materials.
Tip: Work on metals at a low speed and process as if it were hardwood.
Plastics must be processed at low speeds because of their tendency to melt during
processing.
Operating multi tool at a higher speed will lessen vibration.
8.4.3 Honing stone (H)
Use: Cleaning and shaping grinding stones
8.4.4 Polishing discs (C)
Use: Polishing metals and grinding stones.
Attention: Only polish with the sides of the disc. The head of the stone would will leave
scratches on the work piece.
These can be used in combination with the polishing paste (A).
8.4.5 Cutting disc (F)
Use: Cutting or slitting bolts, screws , sheet metal, thin wood and plastic.
8.4.6 Orbital sander (B)
Use: Sanding , smoothing and shaping wood and fiberglass.
8.4.7 Cleaning brushes (D & E)
▪ The nylon brushes can be used to clean sensitive materials such as wood and plastics or
similar.
▪ The copper brushes can be used to clean hard metals such as iron and steel or similar.