POWX0260 EN
Copyright © 2019 VARO P a g e | 6 www.varo.com
7.6 For proper operations
▪ Hold the drill with your first two fingers on the ON/OFF switch (8).
▪ Use the auxiliary handle subassembly (3) where possible to gain extra control and to
prevent fatigue.
▪ For wood, use twist drill bits, spade bits power auger bits, or hole saw.
▪ For metal use high seed steel twist drill bits or hole saws.
▪ For masonry, such as brick, cinder block, cemetery, etc, use carbide tipped drill bits.
▪ Use enough pressure to keep the bit biting but do not push so hard that do not stall the
motor or damage the bit.
▪ Always apply pressure in a straight line with the bit.
▪ Hold the drill firmly to control the twisting of the drill.
Warning：If the drill stalls, release the trigger immediately, remove the drill
from the work and determine the cause of the stalling. Do not click the switch
on and off as this can damage the motor.
▪ To minimize the chance of stalling and breaking through the material, reduce the pressure
on the drill and ease the bit through the last part of the hole.
▪ Keep the motor running when pulling the bit back out of a drilled hole. This will help
prevent jamming.
8 MAINTENANCE
Do not attempt to make any adjustments while the tool is in operation.
Clean out any accumulated dust with a brush or dry cloth.
Do not allow petroleum-based products to come into contact with plastic parts as they contain
chemicals, which could damage, weaken or destroy plastic.
9 TECHNICAL DATA
