POWPG60140 EN
Copyright © 2019 VARO P a g e | 8 www.varo.com
9.2.3 To stop the engine
▪ Push the on/off switch to the “O” position and hold it down for a few seconds until the
engine stops.
Do not to touch the motor with your hands when the machine is running or
has just stopped running, it may hurt you because the surface might be hot.
9.2.4 Use as a blower (Fig. 5)
WARNING: The machine must always be firmly gripped with your right
hand on the upper handgrip during work.
Engine speed should be adjusted to the type of material to be removed:
• use the engine at low speed for lightweight material and small bushes on the lawn;
• use the engine at average speed to move grass and lightweight leaves on pavement or
solid ground;
• use the engine at high speed for heavier materials like fresh snow or voluminous dirt.
WARNING: Always pay the utmost attention to prevent removed material or
dust from injuring people or animals or damaging property. Always assess
wind direction and never work against the wind.
9.2.5 Use as a vacuum collector (Fig 6)
IMPORTANT: The machine must always be firmly held with both hands
during work. Place your right hand on the upper handgrip and your left hand
on the lower handgrip so that the bag is on the left‐hand side of the
operator.
▪ When used as a vacuum collector, it is best to use the engine at average/high speed.
▪ During collection, keep the rounded end of the tube a few centimeters off the ground. The
bag also works as a filter similar to a common home vacuum. For this reason it is best
that:
o it is always free to expand and the support strap not tangled;
o it is not fully filled;
o collected objects that could jeopardize integrity are promptly removed.
To empty the bag:
▪ switch the engine of;
▪ open the zipper (1) and empty the bag without disconnecting it from the fitting tube.
IMPORTANT When used as a vacuum collector, do not collect damp grass or
leaves to avoid clogging the rotor and coil.
When using the machine as a vacuum collector, there is a risk of inadvertently suctioning
objects which can obstruct the machine and block the rotor. In this case:
▪ switch the motor off immediately; disassemble the vacuum tube;
▪ remove the foreign body from inside the vacuum inlet.
Check if nothing is blocking the rotor before using the machine again.
