POWEBG7560 EN
Copyright © 2019 VARO P a g e | 9 www.varo.com
8.2 Insertion of battery (Fig. 1)
WARNING Always remove battery pack (12) and key (2) from your tool when
you are assembling parts, making adjustments, cleaning, or when not in use.
Removing battery pack and key will prevent accidental starting that could
cause serious personal injury.
▪ Raise the battery cover (7).
▪ Place the battery pack (12) in the mower.
▪ Align raised ribs on battery pack with grooves in the mower’s battery port.
▪ Push down into battery compartment until the battery clicks into place.
▪ Lower the battery cover.
WARNING Make sure the latch on the top of the battery pack snaps in place
and the battery pack is fully seated and secure in the mower’s battery port
before beginning operation. Failure to securely seat the battery pack could
cause the battery pack to fall out, resulting in serious personal injury.
8.3 To remove battery pack
▪ Raise the battery cover.
▪ Press and hold the battery latch button at the top of the battery pack.
▪ Remove battery pack from the mower
WARNING To avoid serious personal injury, always remove the battery pack
and key when carrying or transporting the tool.
9 ASSEMBLY
9.1 Mounting the push handle
▪ Insert the both ends of lower handle (8) into the holes of the mower body then fully tighten
the clamping screws (a) by using a screwdriver. (Fig. 2)
▪ Connect upper and lower handle bars with supplied screws and knobs in one of the three
holes for height adjustment, make sure that the cable is above the lower handle bar (8)
NOTE: If the upper handle is loose or separated from the lower handle,
tighten the knobs on the upper handle locks by turning them clockwise.
9.1.1 To lower the handle assembly
▪ Loosen the upper handle knobs (9)
▪ Lower the upper handle bar (10).
9.2 Installing the wire fixed buckle (Fig. 3)
▪ To secure the wire fixed buckle (4) in place.
▪ Make sure the buckle is installed securely.
9.3 Installing the grass catcher (for rear bagging operation) (Fig. 4)
▪ Asssemble two halves and fix them together
▪ Remove key and battery pack.
▪ Lift the rear discharge door.
▪ Lift the grass catcher by its handle and place under the rear discharge door so that the
hooks on the grass catcher are seated onto the slots on the mower housing.
▪ Release the rear discharge door.
