POWAIR0105 EN
Copyright © 2020 VARO P a g e | 4 www.varo.com
7. Test the consistency of the material by making a few strokes on a cardboard target. If
material still appears too thick, add a small amount of thinner. THIN WITH CARE! Do
not exceed paint manufacturer’s thinning recommendations.
5.2 Adjustment
The desired pattern, volume of fluid output and fine atomization can easily be obtained by
regulating the Pattern Adjusting Knob,Fluid (PAINT) Adjusting Knob.
5.2.1 Pattern adjustment:
Turning pattern adjusting knob to the right till the end will make spray pattern round, or
turning left will make spray pattern ellipse.
5.2.2 Fluid (paint) adjustment:
Turning the paint adjusting knob clockwise will decrease the volume of fluid output and
counter-clockwise will increase fluid output.
5.2.3 Operation
1. Begin spraying. Always keep the gun at right angles to the work .
2. Keep the nozzle about 6 to 12 inches from the work surface. Grip the gun keeping
perpendicular with spraying area then move it parallel for several times, Stopping
gun movement in mid-stroke will cause a build up of paint and result in runs. Do not
fan the gun from side to side while painting. This will cause a build-up of paint in the
center of the stroke and an insufficient coating at each end.
3. Trigger the gun properly. Start the gun moving at the beginning of the stroke
BEFORE SQUEEZING THE TRIGGER and release the trigger BEFORE STOPPING
GUN MOVEMENT at the end of the stroke. This procedure will blend each stroke
with the next without showing overlap or unevenness .