481005
8
Verklein
Vergroot
Pagina terug
1/12
Pagina verder
POW751 EN
Copyright © 2016 VARO P a g e | 8 www.varo.com
6.5 Spraying techniques (fig d.)
To obtain the best results, keep your spray gun level and parallel to the surface at all times.
Keep the nozzle 25 - 30 cm from the surface and spray evenly from side to side or up and
down. Do not spray at an angle as this will lead to paint runs on the surface. Use smooth and
even strokes. When spraying large areas, use a criss-cross pattern as shown.
Fig E.
Never start or stop the spray gun while it is aimed at the surface to be sprayed. Evenly control
the speed of movement of the spray gun. A fast speed of movement over the surface will give
a thin coat and a slow speed will give a heavy coat. Apply one coat at a time. If a further coat
is required, make sure you observe the manufacturers drying time recommendations before
applying a second coat. When spraying small areas, keep the output control on a low setting.
This will avoid using too much paint and prevent overspray. Where possible avoid stopping
and starting when spraying an object. This can lead to too much, or not enough paint being
applied. Do not tip the spray gun to more than 45 °C
6.6 Fitting and using the flexible nozzle (fig. F)
The flexible nozzle extension should be used to spray flat or horizontal surfaces. It should
also be used in areas with limited access. To fit the flexible nozzle, unscrew the basket nozzle
and attach the flexible nozzle in its place Replace the basket nozzle on the end of the flexible
nozzle and tighten.
7 CLEANING AND MAINTENANCE (FIG. G.)
Always remember to disconnect from the mains supply before cleaning the
spray gun or paint container.
It is essential that the spray gun is cleaned thoroughly after every use. Failure to clean it will
almost certainly result in blockages and it may not operate when you next come to use it! The
guarantee does not cover cleaning a sprayer that has not been properly cleaned by the user.
7.1 The following action must be taken after every use.
Empty any remaining material from the container.
Clean the container thoroughly with the thinner that was used.
Pour some thinner into the container and spray through the spray gun until only clean
thinner is coming out of the nozzle.
Thoroughly clean the paint pick up pipe and filter with thinner.
Clean the basket and nozzle and remove any other debris or paint that remains.
Turn the spray gun upside down and apply a few drops of light oil to the two apertures (F).
This will lubricate the piston and cylinder.
If your spray gun should require extra internal cleaning, it may be necessary to disassemble it.
If so the following actions should be taken.
Remove the plug from the mains socket.
Remove paint container, pick up pipe and filter.
Undo the 4 screws (G).
Take off the pump assembly.
Release the nozzle (H), valve (J), piston (K) and spring (L)
Clean the cylinder (M) and all parts thoroughly with solvent.
Apply a few drops of light lubricating oil to the piston, spring and cylinder.
Reassemble the spray gun.
8

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Powerplus POW751 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Powerplus POW751 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,37 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Powerplus POW751

Powerplus POW751 Gebruiksaanwijzing - Nederlands - 12 pagina's

Powerplus POW751 Gebruiksaanwijzing - Deutsch - 12 pagina's

Powerplus POW751 Gebruiksaanwijzing - Français - 13 pagina's

Powerplus POW751 Aanvulling / aanpassing - Alle talen - 2 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info