OO
OO
PP
PP
EE
EE
NN
NN
II
II
NN
NN
GG
GG
1. Rest the board on the floor.
2. Unfasten the fixing band (10) to allow board to open (fig. 4)
3. Pull the opening handle (2) upwards and open the board (1), supporting it as it rises
to the right height position. Adjusting the regulation handle (2), you can bring the board
up to the required height.
4. Unwind the supply cable (8) from its storage (6) (Fig.5)
5. Open the Vaporella supporting-grill (3) (Fig. 3) by lifting it and turning it until the right
horizontal position is reached
6. Fit the flex holder (9) to the appliance.
UU
UU
SS
SS
EE
EE
1a. Insert the plug in the socket.
2a. Push the on/off switch (4), which will light up. At this point the ironing surface starts
to heat up.
3a. Wait for a few minutes to allow the ironing surface to reach the operating temperature.
4a. By pushing the function switch (5) (Fig. 2) on position (I), the board will allow you to
swell the clothes with a “hot blow”, in order to be able to gently skim with the iron the
most delicate clothes, ironing them with steam only.
5a. By pushing the function switch (5) (Fig. 2) on position (II), the board will hold the clothes
to the surface and eliminate the residual humidity.
Note: it is important to always use the aspirator while you use the steam iron in order to
avoid the formation of water condensation inside the ironing board.
CC
CC
LL
LL
OO
OO
SS
SS
II
II
NN
NN
GG
GG
1b. Switch off the on/off switch (4).
2b. Disconnect the supply plug.
3b. Close the Vaporella supporting-grill (3).
4b. Pull the opening handle (2) and support the board (1) as it descends to the floor.
5b. Lift the ironing board vertically with the point downwards.
6b. Fasten the band (10) as show in fig. 4
7b. Rewind the supply cable (8) to its storage (6) as shown in figure (5)
8b. The ironing board can now be stored.
WW
WW
AA
AA
RR
RR
NN
NN
II
II
NN
NN
GG
GG
•In case of damage of malfunction, do not try to disassemble the appliance but address
to the authorised Polti After-Sales Service nearest to you.
• ATTENTION! The supply cable must be replaced by the manufacturer or its After-Sales
Service, so as to prevent any risk.
• ATTENTION: if you iron sitting down, do not place your legs under the ironing board, the
steam can cause burns.
ENGLISH
