455271
50
Verklein
Vergroot
Pagina terug
1/52
Pagina verder
50
En
10
Additional Information
The power does not turn on.
Connect the power plug to the wall outlet.
Disconnect the power plug from the outlet, and insert
again.
Make sure there are no loose strands of speaker wire
touching the rear panel. This could cause the receiver
to shut off automatically.
The unit does not respond when the buttons are
pressed.
No sound is output when a function is selected.
Make sure the component is connected correctly
(refer to pages 5 to 14).
Press MUTING on the remote control.
Adjust MASTER VOLUME.
Press the MONITOR button.
Press SPEAKERS to select the speakers you
connected.
No image is output when a function is selected.
Make sure the component is connected correctly
(refer to pages 5 to 14).
Press the correct function button.
Considerable noise in radio broadcasts.
Tune in the correct frequency.
Connect the antenna (refer to page 10).
Route 2 RF and digital cables away from the
antenna terminals and wires.
Fully extend the FM wire antenna, position for best
reception, and secure to a wall.
Connect an outdoor FM antenna (refer to page 10).
Adjust the direction and position for best reception.
Connect an additional internal or external AM
antenna (refer to page 10).
Turn off the equipment causing the noise or move it
away from the receiver.
Place the antenna farther away from the equipment
causing the noise.
Broadcast stations cannot be selected automatically.
Connect an outdoor antenna (refer to page 10).
No sound from surround or center speakers.
Refer to “SPEAKERS setting mode” on page 16 to
check the speaker settings.
Refer to “Setting the volume level of each channel” on
page 20 to check the speaker levels.
Connect the speakers (refer to page 11-13).
Make sure that both A and B sets of speakers are not
switched on at the same time (A+B setting).
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with
this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other
components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks
listed below, ask your nearest PIONEER authorized service center or your dealer to carry out repair work.
If the unit does not operate normally due to external
effects such as static electricity.
Disconnect the power plug from the outlet and insert
again to return to normal operating conditions.
Sound is produced from other components, but not
from LD or DVD player.
Set SIGNAL SELECT to “DIGITAL” or “ANALOG”
according to the type of connections made (refer to
page 27).
Set the digital input settings correctly (refer to pages
19).
Make digital connections (refer to page 5-6) and set
SIGNAL SELECT to “DIGITAL” (refer to page 27).
Refer to the instruction manual supplied with the
DVD player.
No audio is output when software with DTS is
played back.
Make sure your DVD is digitally connected to this
receiver (refer to page 5-6) and set the SIGNAL
SELECT to “DIGITAL”.
When a search is performed by a DTS compatible
CD player during playback, noise is output.
This is not a malfunction, but be sure to turn the
volume down to prevent the output of loud noise
from your speakers.
Cannot be remote controlled.
Replace the batteries (refer to page 4).
Operate within 7 m, 30° of the remote sensor on the
front panel (refer to page 4).
Remove the obstacle or operate from another
position.
Avoid exposing the remote sensor on the front panel
to direct light.
The display is dark or off.
Press
FL DIMMER on the remote control repeatedly
to return to the default.
50

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Pioneer-VSX-D710S

Zoeken resetten

  • Pioneer VSX-D710S Versterker (Poweroff probleem)
    Hij gaat aan en dan staat er poweroff en gaat dan weer uit. Gesteld op 26-1-2022 om 17:59

    Reageer op deze vraag Misbruik melden
  • Hoe kan ik de bas/treble instellen bij een D710S?
    Ik kan het niet meer vinden in de handleiding.
    Ik heb per ongelijk de treble op 6 gezet.
    Nu kan ik het niet meer terug vinden.
    Gesteld op 2-8-2021 om 16:44

    Reageer op deze vraag Misbruik melden
  • HAllo. Als ik dit apparaat aanzet. gaat ie vanzelf weer uit met een power off melding. Wat kan dit zijn Gesteld op 20-6-2014 om 17:20

    Reageer op deze vraag Misbruik melden
    • hallo
      ik had het zelfde probleem
      oplossing haal de stekker uit het stopcontact voor 2 uur
      dan weer aansluiten en het is opgelost
      mvg matt Geantwoord op 26-6-2014 om 18:47

      Waardeer dit antwoord (1) Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Pioneer VSX-D710S bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Pioneer VSX-D710S in de taal/talen: Engels als bijlage per email.

De handleiding is 4,48 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Pioneer VSX-D710S

Pioneer VSX-D710S Gebruiksaanwijzing - Nederlands - 108 pagina's

Pioneer VSX-D710S Gebruiksaanwijzing - Deutsch - 52 pagina's

Pioneer VSX-D710S Gebruiksaanwijzing - English - 52 pagina's

Pioneer VSX-D710S Gebruiksaanwijzing - Français, Italiano - 108 pagina's

Pioneer VSX-D710S Gebruiksaanwijzing - Português - 108 pagina's

Pioneer VSX-D710S Gebruiksaanwijzing - Espanõl - 108 pagina's

Pioneer VSX-D710S Gebruiksaanwijzing - Svenska - 108 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info