572156
45
Verklein
Vergroot
Pagina terug
1/48
Pagina verder
9 Additional Information
45
Symptom
Playback sound is
muddy or distorted;
high frequency sounds
are excessively
emphasized.
Timer doesn’t operate.
Remote control unit
doesn’t work.
Power won’t turn on to
the deck or CD receiver.
Remote Locator
function doesn’t work
Likely cause
The Dolby NR setting is not the same as that
used during recording.
Clock isn’t set to the correct current time.
Power interruption has caused the clock to be set
to the incorrect time (when the clock display is
flashing).
Batteries are exhausted.
A fluorescent lamp is located close to the remote
control unit.
The remote control unit is not pointed at the
signal receiver on the display unit.
System cable connection is incorrect.
The microphone in the remote control is covered
The remote control is too far away.
The battery in the remote control is dead.
The slide switch is in the OFF position.
The interval between claps is too long or too
short.
Remedy
Set the Dolby NR system to the same setting as
that used during recording (see p.22).
Reset the clock to the correct current time
(see p.16).
Reset the clock to the correct current time
(see p.16).
Load new batteries.
Remove the fluorescent lamp from the area of
the remote control unit.
Point the remote control unit at the remote
sensor (located on the right side of the display
unit) when operating.
Connect the system cable correctly.
This is not a malfunction.
Move to a different location and try again.
Replace the battery.
Slide the Remote Locator switch to the ON
position
The interval should be about a second.
When the system is installed near a television set, magnetic influence from the speakers may cause the television’s picture to be
distorted. This symptom frequently occurs when using an indoor antenna; in this event, install an outdoor antenna, or separate
the system farther from the television.
Static electricity and other outside electrical influences may cause the system to operate incorrectly. In such cases, unplugging
and reconnecting the power cord may help correct the problem.
More than one of the same kind of component (CD receiver, MD recorder, or cassette deck) cannot be connected at the same
time.
NOTE
Setting the tuner’s frequency interval:
FM broadcasts are normally tuned at 50kHz intervals and AM broadcasts at 9kHz intervals, but this setting can be changed to
100kHz (FM) and 10kHz (AM) if desired in the following way:
1. Switch the unit into standby mode.
2. Press
MENU and choose TUNER F. STEP using the $ or button. Press SET to select it.
3. Switch between
AM 9K (FM 50K) and AM 10 K (FM 100 K) using the $ and buttons. Press SET to select.
45

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Pioneer S-L8 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Pioneer S-L8 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,65 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info