606571
3
Verklein
Vergroot
Pagina terug
1/7
Pagina verder
Oxford Hotgrips instructions v.8 switch - 09/07/12
3
Tools needed:
A course and ne le for smoothing the throttle slider tube
Glass paper for cleaning the handlebars
Cable snippers or pliers
Standard motorcycle tools to remove the seat, fairing panels and battery connections
C: Fitting and Wiring Instructions for Motorcycles
Your Oxford HotGrips are designed as a replacement for the handle bar grips already fitted to the motorcycle.
Hotgrips will t onto most motorcycles that use 22mm or 7/8” Ø handlebars. The grip has an open end to allow for
the bar end weight to be refitted without the need to trim the grip. If the end of the Hotgrip does need to be trimmed
to ensure that a bar-end weight can be tted without fouling the Hotgrips, then it is advisable to trim up-to the point
shown in the diagram below. This ensures that the heating elements do not get cut.
The left and right grip are different sizes:
One is designed to t over the left handlebar and has an internal diameter of approximately 22mm.
The other ts over the throttle slider on the right handlebar and has a diameter of approximately 25mm.
D: Fitting Procedure
1. Remove the existing handlebar grips.
2. Clean the left handlebar ensuring that the bars are smooth and free of glue and residue.
3. The bar should measure a consistent 22mm diameter.
4. When the right grip is removed there is a nylon throttle slider underneath. This may need to be removed and any
raised areas smoothed off to ensure that the diameter is a consistent 25.6mm.
This often involves filing off the raised ridges that were formed on the throttle slider.
Trim length here (picture below)
E: Trial fit the Oxford HotGrips
1. Always “dry t” the grip to the bar rst, to ensure that the grip is a snug t before using the adhesive.
2. The HotGrips have a unique internal tube that can expand to t over the handlebar.
3. This makes them easier to t over handlebars that have inconsistent diameter bars due to manufacturing
tolerances.
4. If the grips are too tight to slide on with only gentle effort, do not force them on or damage may occur. Check the
dimensions of the handlebars again and adjust as necessary.
5. If the HotGrips do not slide on easily, check if there is any excess rubber on the inside of the grip which may have
seeped through the expansion slot during manufacturing. If so, use a long file and gently remove the excess
rubber with the edge of the file.
6. When sliding the grips onto the handlebars it is possible to twist them into place until they reach the correct
finished position.
Trim lengths
Trim lengths Trim lengths
OF690 Adventure OF691 Touring OF692 Sports
3

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Oxford-OF692-HotGrips

Zoeken resetten

  • Hallo
    Ik heb oxford handverwarming, als ik aanzet en tijd heb gereden.
    Gaat na enige tijd het groene lampje knipperen,wat kan hier de oorzaak van zijn.
    Gr Rene Gesteld op 15-11-2022 om 05:54

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Oxford OF692 HotGrips bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Oxford OF692 HotGrips in de taal/talen: Engels als bijlage per email.

De handleiding is 2,02 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Oxford OF692 HotGrips

Oxford OF692 HotGrips Gebruiksaanwijzing - Deutsch, English, Français, Italiano, Espanõl - 42 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info