*Insert plug to the electrical outlet, and the indicator light turns on.
*Press “ON/SPEED” button to choose the wind for low, Med, High speed that matches the light on the control
panel.
*Press “MODE” to choose the wind type from one of the following:
“Normal”: Wind flow based on Low/Med/High speed.
“Breeze”: Imitates the flow of natural wind based on strong and soft wind.
“Sleep”: The fan runs for half an hour on strong then soft natural wind mode, then changes to soft natural wind for
the next half hour, and then the fan turns off automatically.
(1).Setting H:
Operation pattern: HStopHStopH
(2).Setting M:
Operation pattern: Mstop MStopM
(3)Setting L:
Operation pattern: LStopLoffL
*Press “SWING” to start oscillation; press again to fix the airflow direction.
*Press “HUMIDITY” to start the humidifying function; mist comes out of the front plate if there is water in the
tank.
The MIST function can be used on its own or along with the fan function to blow the mist into the room.
*Press “TIMER” button to make the fan run for the length of the timer. There are 4 indicator lights for
automatic timing. To set a time of 7.5 hours you need to press 15 times and all the 4 indicator lights light up.
* The Remote Control must be pointed towards the Remote Sensor on the main unit for best results. If the
remote control doesn't operate as expected, replace the batteries (2 pcs, AAA battery).
*Press “NEGATIVE-ION GENERATOR ” to start the negative-ion function.
Caution
* Do not touch / pull out / put back the water tank when the unit is plugged into a power source. Make sure it
is physically disconnected from the mains before doing anything with the water tank.
* When the water level is too low, the safety switch will cut out operation of the mist function. Unplug the
unit and refill the water tank for further operation.
* Do not let dust or other particles collect on the mist plate - if the mist outlets are blocked, the mist function
could malfunction.
* Before cleaning the unit, make sure it is completely disconnected from the power source. Make sure your
hands are not wet when unplugging the unit.
* Do not use very hot water in the water tank - use water less than 40 degrees Celsius.
* Use only water in the water tank. Do not add chemicals or oils or any other additive.
* Infants,the disabled and the elderly should not be in the direct airflow from the fan for long periods of time.
