612933
2
Verklein
Vergroot
Pagina terug
1/4
Pagina verder
EBR - 2
CONTROL OF LIQUID LEVEL
INSTRUCTIONS FOR USE
DESCRIPTION
The EBR - 2 enables the user to fill up and drain wells and tanks.
INSTALLATION
WARNING: The installation and assembly of electrical appliances must
be carried out by an authorised fitter or wireman.
The apparatus is equipped with an internal safety circuit to protect it
against interference. However, some particularly strong electromagnetic
fields cause disturbance to operation.
Interference can be prevented if the following installation standards are
taken into account.
- The apparatus must not be installed close to inductive circuits
( motors, engines, transformers, contact units, etc. ).
- It is advisable to provide a separate line for power supply
( where necessary it should be equipped with a filter network ).
- The inductive charges must be provided with interference
suppressors, such as varistors and RC currents.
The cable used for the sensors must be as short as possible. Insulated
cabling at least 1.5 mm
2
. shall be used. If this distance has to be greater
than 100 m. for any reason, or if disturbance is envisaged, it is advisable
that the cable be metal clad, either using earthed, screened cable or a
dedicated metal conduit.
Wires have to be connected to the top part of the probes, assuring a good
connection with the screw.
ASSEMBLY:
It must be installed inside a switch cupboard, with a 35 mm. symmetrical
profile, in accordance with Standard EN 60715 ( Rail Din ).
CONNECTION:
It must be connected in accordance with the following diagram:
DESCRIPTION OF THE SENSORS
Sensor 1: Minimum tank level
Sensor 2: Maximum tank level.
Sensor 3: Located at the bottom of the well or, if metal,
connected to the casing.
Sensor 4: Minimum safety level in the well.
Sensor 5: Minimum service level in the well.
OPERATION
The EBR - 2 enables the user to drain a well until the water level lies
below Sensor 4 (opening circuit 9 - 10), and will not return to service until
the water level reaches sensor 5 (closing circuit 9 - 10). The EBR - 2 will
set the pump in operation (closing circuit 7 - 9), when the level in the tank
lies below sensor 1, and will stop the pump (opening circuit 7 - 9) when it
reaches sensor 2.
STATE OF THE APPARATUS
Tank full ( 9 - 7 open ) Tank led ON.
Tank empty ( 9 - 7 closed). Tank led OFF.
Well full ( 9 - 10 closed) Well led ON.
Well empty ( 9 - 10 open ). Well led OFF.
ADJUSTING THE CONDUCTIVITY
Although the apparatus is calibrated before it leaves the factory, if the
level in the well is above level 5 and the led fails to light up, adjust the
potentiometer in the well until it does light up. If the level in the tank
reaches sensor 2 and the led in the tank fails to light up, adjust the
potentiometer until it does.
If the user wishes to adjust the EBR - 2 more accurately the tank
terminals ( terminals 1 - 2 ) have to be disconnected when the
conductivity is being adjusted. The well terminals ( terminals 4 - 5 ) have
to be disconnected before adjusting the tank conductivity.
TECHNICAL CHARACTERISTICS
Supply 230 V~ or 400 V~ 50-60 Hz
Breaking Capacity 8(2) A/250 V~; 4(1) A/400 V~
Consumption 4 VA max.
Sensitivity From 0 kΩ to 50 kΩ
Sensor Voltage 13 V
Operation Temperature -10 ºC to +45 ºC
Type of Protection IP 20 in accordance with
Standard EN 60529.
UNE 20324
Class de Protection II in accordance with Standard
EN 60335 when correctly
assembled
DIMENSIONS
A016.23.49039
M
1110
9
12
8
7
TANK
WELL
5
EBR-2
2
1
3
4
6
M
0 V
230V
B
6-11 230V
6-12 400V
POTENTIOMETER
ADJUSTMENT
CONDUCTIVITY
TANK
GAUGE
LUMINOUS
TANK
POTENTIOMETER
ADJUSTMENT
CONDUCTIVITY
WELL
GAUGE
LUMINOUS
WELL
On
On
123
534
78910
ORBIS TECNOLOGÍA ELÉCTRICA, S.A.
Lérida, 61 E–28020 MADRID
Teléfono:+ 34 91 5672277; Fax:+34 91 5714006
E-mail: info@ orbis.es
http://www.orbis.es
71.5
59.5
86
45
2

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Orbis EBR - 2 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Orbis EBR - 2 in de taal/talen: Duits, Engels, Frans, Spaans als bijlage per email.

De handleiding is 0,23 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info