589209
51
Verklein
Vergroot
Pagina terug
1/53
Pagina verder
50 51
Q&A
Q The FC-1 cannot be turned on.
A It cannot be turned on in the following cases.
When the connector(s) for the unused flash (either the Ring Flash or Twin Flash) is not
capped.
When both the Ring Flash and Twin Flash are connected.
Q Is multi-flash shooting possible in the TTL AUTO mode?
A No, it is not possible.
Q Why does the flash get hot after successive firing?
A The batteries generate heat when flash firing is repeated successively. In this case, use the
flash at intervals until the light-emitting section and batteries cool down.
Q Why can’t I mount the FC-1 on the camera?
A It cannot be mounted if the lock pin is in the out position. If this is the case, turn the lock ring all
the way in the opposite direction to [fl LOCK] until it stops. Once the lock pin is in the in
position, you can mount the FC-1 on the camera (page 14).
Q Why doesn’t the control mode change when I press the MODE button?
A When the Macro Flash System is connected to certain types of communication-capable cam-
era, the flash control mode may only be controlled from the camera.
Q What is the recommended white balance setting for the camera when using the flash?
A The auto white balance mode is recommended. If you use the manual white balance mode,
set the color temperature to 5500K. Note that the color temperature varies depending on the
flash shooting conditions.
Q When the Olympus E-1 Four Thirds System digital camera enters the sleep mode, the FC-1’s
control panel display turns off. Is this normal?
A Ye s, it is normal. When the E-1 enters the sleep mode, so does the FC-1. When the camera
wakes up, so does the FC-1.
Q Does the FC-1 also turn off when the Olympus E-1 digital camera is turned off?
A When the Olympus E-1 Four Thirds System digital camera is turned off, the FC-1 enters the
sleep mode. When the E-1 is turned on again, the FC-1 also turns on. When you want to turn
off the FC-1, turn off the FC-1 before turning off the E-1. In addition, when connected to a
camera without communication capability, the FC-1 enters the sleep mode if it is not operated
for about 60 minutes.
MAIN SPECIFICATIONS
Macro Flash Controller FC-1
Model Number : FS-FC1
Type : External flash controller for digital still camera
Light-emitting device
: Ring Flash RF-11 or Twin Flash TF-22, exchangeable.
Auto power OFF :
Interlocks with the auto power OFF operation of a camera with communication capability.
Illuminator : Automatic firing at low intensity, possible only when a camera with com-
munication capability is connected.
Standard effective distance
:
0.2 to 3 m (0.7 to 9.9 ft) (Variable depending on the camera and lens in use.)
Power supply : AA (R6) alkaline dry cell batteries (LR6) x 4,
AA (R6) Ni-Cd batteries x 4,
AA (R6) Ni-Mh batteries x 4,
AA (R6) Ni-Mn batteries (ZR6) x 4,
AA (R6) lithium batteries (FR6) x 4 or
3 V lithium battery pack (Olympus LB-01) x 2
External power supply
:
Flash High Voltage Set SHV-1 (optional)
Dimensions : 78(W) x 141(H) x 119(D) mm (3.1 x 5.6 x 4.7 in.) (excluding protrusions)
Weight : 320 g (11.3 oz) (excluding batteries)
Operating environment
:Temperature: 0 to 40°C (32 to 104°F).
Humidity: No more than 80% (without condensation).
Ring Flash RF-11
Model Number : FS-RF11
Type : External flash for digital still camera
Guide numbers : TTL AUTO : 11
MANUAL : 0.7 to 11
Firing angle : 8
Flash emission period
: Approx. 1/560 sec.
Flash emission count
: Approx. 250 times (using the LR6-type AA (R6) alkaline dry cell batter-
ies) or approx. 420 times (using the LB-01 lithium battery packs). (Vari-
able depending on shooting conditions)
Recharge time : Approx. 4 seconds (using the AA (R6) alkaline manganese batteries) or
approx. 4 seconds times (using the LB-01 lithium battery packs).
Flash modes : TTL AUTO and MANUAL
Illuminator : 4 lamps built in.
Lens mount : Bayonet
Cable length : Approx. 100 mm (3.9 in)
Dimensions : 120(W) x 135.5(H) x 24(D) mm (4.7 x 5.3 x 0.9 in.) (excluding cable)
Weight : 145 g (5.1 oz)
Operating environment
:Temperature: 0 to 40°C (32 to 104°F).
Humidity : No more than 80% (without condensation).
(From full flash activation to
lighting of Charge lamp)
51

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Olympus FC-1 Macro Flash System bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Olympus FC-1 Macro Flash System in de taal/talen: Engels als bijlage per email.

De handleiding is 4,51 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info