FOR CANADIAN USERS
INDUSTRY CANADA NOTICE
The Load Number of this modem is 3.
The standard connecting arrangement code for this equipment as specified in CP-01, Section 1.8.3
is CA11A.
The Load Number assigned to each terminal device denotes the percentage of the total load to
be connected to a telephone loop that is used by the device to prevent overloading. The termination
on a loop may consist of any combination of devices subject only to the requirement that the total
of the load numbers of all devices does not exceed 100.
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital
apparatus as set out in the interference-causing equipment standard entitled "Digital Apparatus",
ICES-003 of the Industry Canada".
Cet appareil numérique respecte les limites de bruits radioélectriques applicables aux appareils
numériques de Classe B prescrites dans la norme sur le matériel brouilleur: "Appareils Numeriques",
NMB-003 édictée par le ministre des Communications".
The Industry Canada label identifies certified equipment. This certification means that the
equipment meets certain telecommunications network protective operational and safety require-
ments. Industry Canada does not guarantee the equipment will operate to the user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the
facilities of the local telecommunications company. The equipment must also be installed using an
acceptable method of connection. In some cases, the company's inside wiring associated with a
single line individual service may be extended by means of a certified connector assembly
(telephone extension cord). The customer should be aware that compliance with the above
conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility
designated by the supplier. Any repairs or alterations made by the user to this equipment, or
equipment malfunctions, may give the telecommunications company cause to request the user to
disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power
utility, telephone lines and internal metallic water pipe system, if present, are connected together.
This precaution may be particularly important in rural areas.
CAUTION: Users should not attempt to make such connections themselves, but should contact
the appropriate electric inspection authority, or electrician, as appropriate.
