609460
82
Verklein
Vergroot
Pagina terug
1/124
Pagina verder
ENGLISH USER MANUAL
20 SCRUBTEC R 466 - R 471 - R 471C - BOOST
®
R4 9098960000(1)2011-04 A
Battery discharge during operation
Until the green warning light (62) stays on, the batteries allow the machine to work normally.1.
When the green warning light turns off and rst the yellow warning light then the red warning light turn on, the batteries must
be charged.
When the yellow warning light turns on the machine residual autonomy will last for a few minutes (depending on the
characteristics of the battery).
When the red warning light turns on the machine autonomy is over: after a few seconds the brushes/pad-holders are
automatically stopped and the deck is automatically lifted. Only vacuum and drive systems still operate, just to dry the wet
oor and move the machine to the appointed charging area.
CAUTION!
Do not use the machine with discharged batteries, to avoid damaging the batteries and reducing the battery life.
NOTE
In case the machine drive system cannot be used in order to move the machine, see Pushing/Towing The Machine
paragraph.
TANK EMPTYING
An automatic oat shut-off system (27) turns off the vacuum system when the recovery tank (19) is full.
The vacuum system deactivation is signalled by a sudden increase in the vacuum system motor noise frequency, and the oor is
not dried.
CAUTION!
If the vacuum system turns off accidentally (for example, when the oat is activated because of a sudden
machine movement), to resume the operation: turn off the vacuum system by pressing the switch (65), then
open the cover (20) and check that the oat inside the grid (27) has gone down to the water level. Then close the
cover (20) and turn on the vacuum system by pressing the switch (65).
When the recovery tank (19) is full, empty it according to the following procedure.
Recovery tank emptying
Stop the machine by releasing the pedal (4).1.
Lift the brush/pad-holder deck and the squeegee by pressing the pedal (63).2.
Drive the machine to the appointed disposal area.3.
Empty the recovery tank with the hose (24).4.
Remove the container with debris collection grid (26), empty it and clean it with clean water. Then install it on the suction hose 5.
in the tank.
Then, rinse the tank with clean water.6.
Solution/clean water tank emptying
Perform steps 1 to 3.7.
Remove the adapter (45) from its housing inside the battery compartment.8.
Install the adapter (A, Fig. 6) on the squeegee vacuum hose (B), then fasten it to the drain tap (C).9.
Turn the ignition key (58) to “I” and turn on the vacuum system with the switch (65).10.
Open the drain tap (C) to drain the tank (22).11.
The tap (C) is open when it is in the position (D) and it is closed when it is in the position (E).
Then, turn of the vacuum system and drain the recovery tank (19) with the hose (24).12.
When the procedure is over, close the drain tap (C), remove the adapter (A) and install the vacuum hose (B) on the squeegee 13.
(30).
A
B
C
E
DC
Figure 6
P100440
9098960000(1)2011-04 A.indb 209098960000(1)2011-04 A.indb 20 07/04/2011 15:59:2107/04/2011 15:59:21
82

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Nilfisk-ALTO SCRUBTEC R 466 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Nilfisk-ALTO SCRUBTEC R 466 in de taal/talen: Nederlands, Duits, Engels, Frans als bijlage per email.

De handleiding is 11 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info