665133
23
Verklein
Vergroot
Pagina terug
1/41
Pagina verder
ReadyNAS NV+
23
ReadyNAS Duo and NV+
Boot Menu
Use the boot menu to restart or troubleshoot your ReadyNAS system. The ReadyNAS NV+
has the following boot modes:
Factory reset. Performs a short disk test and then allows you to reset your system to the
factory defaults or switch between X-RAID and Flex-RAID. The system performs the disk
test, which takes about 5 minutes, waits 10 minutes, and then restores the system to its
factory settings. During the 10-minute window, you can shut down the system to avoid
erasing its settings and files, or you can use RAIDar to format the system’s disks as
Flex-RAID instead of X-RAID. If you do not shut down the system or use RAIDar, the
system is reset to factory settings, all files on the system are erased, and the disks are
formatted using the same disk configuration that was previously used. (For more
information about X-RAID and Flex-RAID, see the ReadyNAS RAIDiator 4.1 Software
Manual, which is available at
http://www.readynas.com/documentation.)
OS reinstall. Reinstalls the firmware from the system’s internal flash to its disks. Use the
OS reinstall boot mode when the system crashes and corrupts some configuration files.
OS reinstall boot mode also resets some settings on your system, such as Internet
protocol settings and the administrator password, to defaults.
Tech support. Boots into a low-level diagnostic mode. Use the tech support boot mode
only when instructed to do so by a NETGEAR technical support representative.
Skip volume check. Bypasses file system checks. After a system crash, the system
tries to scan and fix the volume using a file system check. If several problems are found
on a disk, this process can stall, causing the system not to boot. Use this option to skip
the scan and let the system boot. Use this boot mode only if instructed to do so by a
NETGEAR technical support representative. Otherwise, you might lose data.
Memory test. Performs a memory test. The pass or fail result is reported using the
system’s LEDs. Contact a NETGEAR technical support representative to interpret
memory test results.
Disk test. Performs an offline full disk test that can take 4 hours or more, depending on
the size of your disks. To view the results of the test, use the RAIDar discovery tool.
TFTP boot. Replaces the firmware on your system with an image from your computer.
Use this boot mode only if instructed to do so by a NETGEAR technical support
representative.
USB boot. Replaces the firmware on your system with an image from a USB flash drive
connected to the system. Use this boot mode only if instructed to do so by a NETGEAR
technical support representative.
23

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Netgear ReadyNAS Duo bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Netgear ReadyNAS Duo in de taal/talen: Engels als bijlage per email.

De handleiding is 1,98 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info