551332
23
Verklein
Vergroot
Pagina terug
1/25
Pagina verder
ENGLISH ENGLISH
20
21
You might meet abnormal working of this STB with various reasons. Check the following
which may help you.
Problem Possible causes What to do
LED on the front panel fail to
light up/is not lit.
No picture or sound.
Bad picture/blocking error
No startup menu on screen after
turning on STB for the first time.
The remote control is not wor-
king.
Poor picture quality or Less
channels in scanning.
You have forgotten your pass-
word.
Check if the main supply cable is
plugged into the power socket.
Adjust the dish. Check the sig-
nal strength indicator in one of
the channels search submenus.
Check the cable connections,
LNB and other equipment con-
nected to LNB & receiver, or
adjust dish. Replace the LNB.
Replace the cable.
Adjust the dish. Connect an at-
tenuator to LNB input. Change
to a larger dish. Change LNB
with lower noise factor. Replace
the LNB.
Switch the TV to the appropriate
AV input.
Change the batteries (both).
Aim the remote control at the
STB. Check that nothing blocks
the front panel. Check if LED
indicator on the front panel is
showing the time, press the po-
wer button to switch off standby
mode.
Change the LNB power to
14V/19V in Antenna setup
menu.
Contact the dealer or Service
Provider. They will help you set
it up again.
Main supply cable is not con-
nected.
Satellite dish is not aiming to
satellite accurately. No signal or
weak signal. The LNB is faulty.
The cable is faulty.
Satellite dish is not aiming to the
satellite accurately. Signal too
strong. Satellite dish is too small.
LNB noise factor too high. The
LNB is faulty.
The system is connected by
SCART cable and the TV is not in
AV/ EXT mode.
Battery exhausted. Remote con-
trol is not aimed correctly STB is
in standby mode.
Low LNB power or signal loss in
cable.
5. Additional Information5. Additional Information
5.1 Troubleshooting 5.2 Technical Specication
Tuner & Demodulator
MPEG
A/V und Data In/Out Connector
Power Supply
Physical Specication
Frequency Range
Input Connector
Signal Level
RF Impedance
IF Band width
LNB Power
LNB Polarization
LNB Tone Switch
DiSEqC Control
Demodulation
Symbol Rate
FEC Decode
950 MHz to 2150 MHz
F-type, IEC 169-24, Female
-25 to -65 dBm
75Ω¸unbalanced
55 MHz/8Hz(Per 5Msps)
Vertical : +13 V, 14V +/-5%
Horizontal : +18 V, 19V+/-5% Current : 500 mA Max. Overload Protection
22KHz+/-2KHz, 0.6Vpp+/-0.2V
Version 1.0/1.2 Compatible, Tone burst A/B
QPSK/8PSK
1~45Ms/s/SCPC,MCPC
1/2, 2/3, 3/4, 5/6 and 7/8 with Constraint Length K=7
Transport Stream
Profile Level
Input Rate
Aspect Ratio
Video Resolution
Audio Decoding
Audio Mode
Sampling
MPEG-4/H.264, MPEG-2 ISO/IEC 13818
MPEG-4/AVC, MPEG-2 MP@ML, MP@HL
15 Mbit/s Max
4:3, 16:9
720 x 576, 720 x 480, 1280 x 720, 1920 x 1080
MPEG / MusiCam Layer I & II
Single channel/Dual channel/Joint stereo/Stereo
32, 44.1 and 48 KHz
HDMI
LNB IF Input
SPDIF
HDMI OUTPUT
F type, IEC 169-24 Female
COAXIAL OUTPUT
Input Voltage
Power in use
Power in Standby
Protection
100 - 240V AC, 50/60Hz,
Max. 6 W
0.5 W
Separate internal fuse. Input shall have lightening Protection
Weight (net)
Operating Temp
Storage Temp
ca. 360 g
0° to + 40°
-40° to + 65°
23

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Megasat HD 600 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Megasat HD 600 in de taal/talen: Duits, Engels als bijlage per email.

De handleiding is 1,05 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info