25
REFERENCE
REPLACING
THE BATTERIES
WHEN MEMORY
IS FULL
The system can record approximately 54 minutes
of messages (including the time for your an-
nouncements) or a maximum of 60 messages.
When memory is full or 60 messages have been
recorded, message window displays ”Fu”. To
make room for new messages, listen to your
messages and delete some or all of them (see
page 16).
When memory is full, the system will change to
“ANSWER ONLY” mode automatically.
Make sure you have followed all of the instruc-
tions in this manual. If the system does not work
properly, remove the battery and replug the
power transformer. The system should reset and
delete your announcement and message. Your
system should be ready to answer calls and
record messages after you have recorded a new
announcement and set the DTS (see page 9/10).
If the battery used for backup power is missing,
low on power, or incorrectly installed, the message
window displays ”Lo”. To prevent the loss of
messages in the event of a power failure, install
new battery immediately. For best performance,
use heavy duty or alkaline battery.
If new heavy duty or alkaline batteries are
installed, your announcement and messages are
retained in memory for at least 50 hours during
a power failure.
Note:
To avoid losing your announcements or
messages stored in memory, you should leave
the unit connected to the AC power while chan-
ging the batteries. You should, however, dis
-
connect the telephone line cord before changing
the battery.
MALFUNCTION
