11
Mounting the chimney
e. Fix the chimney support (10) with two
screws 5 x 45 mm (11) and two wall
dowels (9) on the wall close to the ceiling.
f. Fit the connection ring S on the top of the
hood with two screws Ø 3,5 x 6,5 mm
(12S) then fit an axhausting pipe long
enough to reach the outside (13S).
g. Prepare the electric connection (14) (see
relative chapter).
h. Fit the chimney (15) and fix it on the
chimney support with two screws
3,0 x 9mm (16).
The lower part of the chimney must be
slided down and inserted on the housing
on the upper part of the hood (17).
i. Fit the two grids (18) on both sides of the
chimney.
Operation
The hood is provided with a motor with four
speed.
For the best performance, we recommend
using the low speeds in normal conditions
and the high speeds in particular cases of
strong odour and vapour concentration.
We recommend starting up the hood a few
minutes before cooking and keeping it
running until all the odours have been
eliminated.
Maintenance
Before performing any maintenance
operation, disconnect the hood from the
electricity.
Metal grease filter
The cooker hood is fitted with metal filters.
Remove the metal filter using the handles
designed for this purpose by pulling them
backwards and then downwards (Fig. 2).
The metal grease filter lasts forever and
must be washed either by hand or in the
dishwasher (65°C) with suitable detergents.
The grease filters must be washed at
least once a month.
Before refitting the filter ensure that it is
perfectly dry.
Position of filters is interchangeable.
ATTENTION! The metal grease filter might
discolours when washed in the dishwasher.
Replacing the lamp
a) Disconnect the hood from the electricity.
b) Remove the grease filters (Fig. 2).
c) Always replace burnt-out lamps with
40Watt max. (E14).
d) Fit again the grease filters.
e) Before calling for repair service because
the hood fails to light up, make sure the
bulbs are screwed in tightly.
Before calling for Repair Service because
the hood fails to light up, make sure the
lamp is well-inserted.
Cleaning
To clean the outside of the hood use a cloth
moistened with denatured alcohol or neutral
liquid detergents.
Never use products containing abrasive.
Attention
Failure to observe the rules for cleaning the
appliance and changing and cleaning the
filters may cause fires.
Therefore, we recommend observing these
instructions.
