442809
4
Verklein
Vergroot
Pagina terug
1/7
Pagina verder
Footcontroller (optional - PEDL-90008)
Footcontroller Factory Settings
Footswitch 1: Wish You Were Clean
Footswitch 2: Mega Rhythm
Footswitch 3: Conjuring Solo
Footswitch 4: Hangar Solo
Programming
The footcontroller can be programmed to store front
panel switches (Switch Store) or complete presets
(Preset Store).
Switch Store
To assign a front panel switch to a footswitch (1),
press and hold the front panel switch and while held
down press the footswitch (1) you wish to assign it to.
The Digital Display (3) will swirl to show that the
footswitch has been assigned. You can then release the
footswitch and front panel switch.
Preset Store
To assign a preset to a footswitch (1), select the
required channel and modify the front panel controls if
required, press and hold the Store switch on the front
panel and while held down, press your chosen
footswitch (1).
The Digital Display (3) will swirl to show that the
footswitch has been assigned. You can then release the
footswitch and Store switch.
Footcontroller Presets are independent of the dedicated
channel presets stored within the amplifier. This allows
you to create a number of presets based on the same
channel/pre-amp setting.
1
3 2
1. Footswitches
In addition to the factory preset tones, when the optional stompware® footcontroller is plugged into the
amplifier an additional four voices will be "unlocked" from the amplifier memory. These voices were programmed by
Dave Mustaine and Andy Sneap and details of the control settings and voice parameters can be found on page 41.
Each footswitch can be assigned a different stored function.
2. LED Status Panel
This always reflects the current status of the amplifier or tuner details:
CLN & OD: Current Channel
REV: Reverb On/Off
FX: FX Section On / Off
Ext FX: External FX Loop On/Off (MG50FX & MG100FX)
Damp: Damping Mode (MG50FX & MG100FX)
Tap: Tap Tempo speed.
3. Digital Display
This display indicates the various functions of the footcontroller.
ENGLISH
5
1. Footcontroller Socket
Jack socket for the connection of the optional footcontroller.
2. Loudspeaker Outputs
Connect the two loudspeaker cabinets provided to the
speaker outputs using the speaker leads supplied.
If you would like to use your MG15HFX amplifier head
with another speaker system (such as a full size 4x12"
cabinet), ensure that the amplifier is provided with a
total load equal to or greater than 8 ohms.
Always use a non-screened Marshall approved speaker
lead when connecting an extension cabinet to these
units.
MP3 / Line In
The 3.5mm MP3 / Line In socket (14) allows the
connection of an external audio source e.g. MP3 or CD
player.
Headphones
The 3.5mm Headphones socket (15) allows the
connection of a pair of headphones. When a jack is
inserted into the headphones socket the unit’s speaker
is muted.
Power
The Power switch (16) turns the amplifier on and off. If
current settings have not been stored they will be lost.
Restoring Settings - WARNING ALL AMP &
FOOTCONTROLLER SETTINGS WILL BE LOST
To restore the unit to Dave’s factory settings (see page
40) you must hold the Store switch (12) while powering
on the unit. The Clean/Crunch (3) and OD (5) lights
will light orange. You can then release the Store
switch (12).
Resetting the amplifier will erase all user Channel
presets and all user footcontroller settings, replacing
them with the factory presets.
MG15FXMSDM Features
* EUROPE ONLY - Note:
This equipment has been tested and found to comply with the requirements of the EMC Directive
(Environments E1, E2 and E3 EN 55103-1/2) and the Low Voltage Directive in the E.U.
* EUROPE ONLY - Note:
The Peak Inrush current for the MG15HFX is 2.5 amps.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
*
Reorient or relocate the receiving antenna.
*
Increase the separation between the equipment and the receiver.
*
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
*
Consult the dealer or an experienced radio/TV technician for help.
Follow all instructions and heed all warnings
KEEP THESE INSTRUCTIONS !
MG15FXMSDM Rear Panel
1 2
4
4

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Marshall Megastack (MG15FXMSDM) bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Marshall Megastack (MG15FXMSDM) in de taal/talen: Engels als bijlage per email.

De handleiding is 3,57 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info