571041
5
Verklein
Vergroot
Pagina terug
1/19
Pagina verder
PREPARATION FOR USE
REAR PANEL CONNECTIONS
All s,gnal connections to the Model 2230, with the
exception of the FM antenna and loudspeakers,
should be made with shielded audio cables. Figure
1 shows the location of input and output jacks on
the rear panel. These jacks are for "permanent"
connections. Front panel jacks and their usewill be
discussed later. The rear panel signal connections
are arranged in stereo pairs. To avoid confusion,
connect one cable at a time between the 2230 and
the other components of your system. In this way,
you will avoid cross-connecting channels or con-
fusing signal SOllrceswith destinations.
PHONO
The phono jacks are intended for use with
magnetic phono cartridges requiring a standard
47,000-ohm resistive load. If hum is heard when
playing records, it is usually evidence of improper
grounding or shielding of the record player or its
connections. Try reversing the polarity of the
turntable's power plug. If this is ineffective,
connect a separate ground wire from the turntable
or record changer frame to the CHASSIS
GROUND binding posts of the Model 2230 If the
tone arm is mounted on a wood panel or is
otherwise insulated from the tu rntable frame,
connect the tone arm mounting base to the
grounding wire with a short wire. If the two pairs
of signal wires in the arm have a single overall
shield, try grounding the shield instead of the arm
Figure 1. Rear Panel Connection Facilities and Adjustments
itself. Keep the two PHONO connecting cables and
the grounding wires close together to minimize
"ground loops."
TAPE IN
The pair of TAPE IN jacks servetwo purposes:
1. With the selector switch in"T APE"position,
signals can be played from a tape recorder
set for playback mode of operation. This
permits playing the tape source stereo-
phonically or monophonically as indicat-
ed by position of MONO pushswitch.
2. With the selector switch in any other
position, and while your tape recorder is
recording, you can monitor the resulting
tape quality by depressing the TAPE
MONITOR pushswitch. This presumesthat
your recorder is equipped with separate
record and playback heads and separate
record and playback electronics.
TAPE OUT
Connecting these jacks to the line or "radio"
inputs of a tape recorder permits recording from
the program source indicated by the selector
switch. The signalsavailable at this pair of jacks are
not affected by the balance, volume, treble, mid,
bass, LOW FILTER, Hi FILTER, LOUDNESS
.and MONO pushswitches on the front panel.
2
5

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Marantz Model 2230 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Marantz Model 2230 in de taal/talen: Engels als bijlage per email.

De handleiding is 12,09 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info