Digital 311
Digital 311
Hand transmitter
Version
1-channel: 868 MHz (Art.-No.: 72 747)
Safety advice
• Before operating this unit please read these
instructions carefully!
• Observe as well the operating instructions of the
RC remote control.
• Only operate the transmitter with view to the
devices to be controlled!
• Have faulty units checked by the manufacturer.
• You are not authorized to carry out changes to
this unit.
Operating mode
The hand transmitter Digital 311 is used to radio
control power-operated blinds, roller shutters,
awnings.
Mounting advice
• Make sure that there is an uninterrupted
connection between transmitter and receiver.
Brickwork and other insulating materials reduce
the range of radio transmission.
• The range of operation is approx. 10 m.
There should be sight contact between
transmitter and receiver or at most only one wall
or floor in between.
• Do not mount this unit near large metal surfaces
and close to the floor. In case you cannot avoid
a mounting near metal surfaces, keep a
minimum distance of 0,1 m.
Initial operation
The hand transmitter already contains a battery so
that it can be used immediately on unpacking.
1. Mount the wall bracket to a
suitable place.
2. Learn the separate channels to the
devices to be controlled.
For this read the operating instructions of the
RC remote control.
Operate the transmitter
1. Push one of the three function buttons
(OPEN, STOP, CLOSE), to contact the device in
question. The LED on the hand transmitter
shortly lights up.
2. When pushing one of the
function buttons again, you can reverse the
travel direction (OPEN, CLOSE), or stop the
operator (STOP).
Change of battery
1. Open the bottom side of the hand transmitter,
e.g. with
a coin.. By turning the coin
separate the housing parts carefully.
2. Change the battery (CR2032).
Observe right poling!
3. Close the housing parts again.
Dispose of used batteries in the specialised trade
or in a recycling bin for old batteries.
Trouble-shooting
• If the LEDs glow only faintly:
Change the battery.
• If the LED does not glow:
Check poling of the battery.
• If the receiver does not react all the same:
Reduce the distance to the RC remote control
or learn the channels of the hand transmitter
again to the RC remote control(s).
Technical details
Power supply: 1x3-V battery, CR 2032
Power consumption: approx. 10 mA
Frequency: 868 MHz
Coding: Easywave
Range of temperature: -20°C to +60°C
Correct use
Only use the Easywave hand transmitters to
operate Easywave RC remote controls.
The manufacturer is not liable for damages that
occur due to improper or incorrect use.
This product fulfils the essential requirements of
the R&TTE directive 1995/5/EG.
The Declaration of Conformity can be looked up
at the manufacturer mentioned in the supply
documents.
Version: 02.2005
#72 973
1 - GB 360243 - M - 0.5 - 0205
LED
CLOSE
OPEN
STOP
Wall bracket
2
