57026
13
Verklein
Vergroot
Pagina terug
1/16
Pagina verder
6.3 Cleaning the appliance
CAUTION
Risk of injury and damage as a result of hot steam!
Hot steam may damage the surfaces and cause burns.
uDo not use any steam cleaners!
NOTICE
Incorrect cleaning damages the appliance!
uDo not use cleaning agents in concentrated form.
uDo not use any scouring or abrasive sponges or steel wool.
uPlease do not use any aggressive, scouring, sand-,
chloride-, chemical- or acid-based cleaning agents.
uDo not use chemical solvents.
uDo not damage or remove the type plate on the inside of the
appliance. It is important for the customer service.
uDo not pull off, bend or damage cables or other compo-
nents.
uDo not allow any cleaning water to enter the drain channel,
ventilation grille or electrical parts.
uPlease use soft cleaning cloths and a universal pH-neutral
cleaning agent.
uPlease use cleaning and care products suitable for contact
with foodstuffs in the appliance interior.
uEmpty appliance.
uPull out the power plug.
uClean plastic outer and inner surfaces with lukewarm
water and a little washing-up liquid.
Do not apply stainless steel cleaning agent to glass or plastic
surfaces to prevent them from being scratched. Darker areas at
the beginning and quite an intensive colour of the stainless
steel surface are normal.
NOTICE
The stainless steel doors are provided with a high-quality
surface coating and must not be treated using the accompa-
nying care product.
Otherwise the surface coating will be affected.
uWipe the coated door surfaces using a soft, clean cloth
only. In case of stubborn dirt, use a little water or a neutral
cleaning agent. A microfibre cloth can be optionally used.
uIf the stainless steel side walls are dirty, clean them using
a commercially available stainless steel cleaning agent.
Then evenly apply the accompanying stainless steel care
product, making strokes in the direction of the grain.
uWipe side walls with a paint finish using a soft, clean
cloth only. In case of stubborn dirt, use a little water or a
neutral cleaning agent. A microfibre cloth can be optionally
used.
uClean items of equipment by hand with lukewarm water
and a little washing-up liquid.
uTo dismantle the shelves: remove trims and side parts.
uTo dismantle door racks: Pull off
protective film from the decorative
trims.
uRemove boxes and covers by lifting
up and out.
After cleaning:
uWipe dry the appliance and items of equipment.
uConnect the appliance and switch it on again.
uSwitch on SuperFrost (see 5.8.4) .
When the temperature is sufficiently cold:
uPut the food back inside.
6.4 Cleaning the IceMaker
The drawer of the IceMaker has to be emptied and slid in.
uTo activate the setting mode: press the SuperFrost button
Fig. 2 (3)
for about 5 s.
wThe display indicates c.
wThe menu symbol
Fig. 2 (17)
shines.
uUsing the Up setting button, freezer compartment
Fig. 2 (5)
/
Down setting button, freezer compartment
Fig. 2 (4)
select I.
uTo confirm: press the SuperFrost button
Fig. 2 (3)
.
uUsing the Up setting button,
freezer compartment
Fig. 2 (5)
/ Down setting
button, freezer compartment
Fig. 2 (4)
select Ic.
uTo confirm: press the Super-
Frost button
Fig. 2 (3)
.
wThe IceMaker moves into the cleaning position and switches
off.
uTo deactivate the setting mode: press the On/Off button,
freezer compartment
Fig. 2 (1)
.
-or-
uWait for 2 minutes.
wThe temperature is indicated again in the temperature
display.
uRemove the drawer.
uClean the ice cube tray and drawer with warm water. If
necessary, use mild washing-up liquid. Then rinse.
uSlide in the drawer again.
If washing-up liquid was used:
uthrow away the first three loads of ice cubes to get rid of any
remaining washing-up liquid.
Either leave the IceMaker switched off in this position or switch
the IceMaker on again (see 5.8.11) .
6.5 Cleaning the dispensing unit
uClean the dispensing unit with a damp cloth.
uClean the ice chute with water and a little washing-up liquid.
uClean drip plate in the dishwasher.
uUse a cloth or sponge to absorb the water in the collecting
trough under the drip plate.
uRemove the ice storage
container with the door in
an open position and
clean with water and a
little washing-up liquid.
uAfter cleaning, slide in the
container again as far as it
will go. If the container will
not slide in all the way,
turn the feed screw
Fig. 9 (1)
.
Fig. 9
Maintenance
13
13

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Liebherr-SBSes7273

Zoeken resetten

  • ijsblokjes zijn onvolmaakt en vriezen aan elkaar,water in ijsblokken bakje vriest ze aan elkaar .
    Werkt anders normaal?
    Ook het gekoelde water heeft te warm volgens de klant.
    Frigo staat op +5 en diepvries op -18
    groetjes Gesteld op 16-3-2012 om 16:53

    Reageer op deze vraag Misbruik melden
    • Tjien ik heb dit ook ?? Heeft een jaar normaal gewerkt en nu merk ik eveneens dat de ik blijkbaar water heb in mijn bak waardoor de ijsblokjes aan elkaar vriezen. Ik heb wel de indruk dat de blokjes volmaakt zijn Geantwoord op 30-3-2012 om 10:07

      Waardeer dit antwoord (4) Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Liebherr SBSes7273 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Liebherr SBSes7273 in de taal/talen: Engels als bijlage per email.

De handleiding is 0.46 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Liebherr SBSes7273

Liebherr SBSes7273 Gebruiksaanwijzing - Nederlands - 14 pagina's

Liebherr SBSes7273 Gebruiksaanwijzing - Deutsch - 16 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info