597566
4
Verklein
Vergroot
Pagina terug
1/5
Pagina verder
8
Wall mounting
The appliance can be wall-mounted.
There are two mounting holes
at the top of the back of the
appliance.
Make sure the wall and the
fasteners can withstand the
weight of the appliance when
fully loaded.
Inserting the grid shelves
The knurled screws supplied are used
to support the grid shelves.
Screw the knurled screws into
the desired position inside the
appliance to the left and right
and insert the grid shelves.
The lower grid shelf only
requires two screws at the
front. The rear part of this grid
shelf rests on the ledge of the
interior container.
Electrical connection
Only operate the appliance with alternating current (AC).
The permissible voltage and frequency are indicated on the type
plate. The position of the type plate is shown in the section entitled
Description of the appliance.
The socket must be properly earthed and protected by a fuse.
The tripping current of the fuse must be between 10 A and 16 A.
The socket must not be situated behind the appliance and must
be easily accessible.
Do not connect the appliance using an exten-
sion cable or extension socket.
Do not use stand-alone inverters (conversion
of direct current to alternating/three-phase
current) or energy-saving plugs. Risk of dam-
age to the electronic control system!
Setting the temperature
Set the temperature inside the ap-
pliance using the temperature
control.
When the control is turned to
"7", the temperature inside the
appliance is at its lowest.
Set the control between "1" and
"7" as required.
Appliance
dimensions
Setting up
• Avoidpositioningtheapplianceindirectsunlightornearcook-
ers, radiators and similar sources of heat.
• Theflooronwhichtheappliancestandsshouldbehorizontal
and level. Compensate for uneven floors with the adjustable
feet.
• StandardEN378specifiesthattheroominwhichyouinstall
your appliance must have a volume of 1 m
3
per8gofR600a
refrigerant used in the appliance, so as to avoid the formation of
inflammable gas/air mixtures in the room where the appliance
is located in the event of a leak in the refrigerant circuit. The
quantity of refrigerant used in your appliance is indicated on
the type plate on the inside of the appliance.
• Theremustbeagapofatleast20cmbetweentheupperedge
of the appliance and the ceiling. Always ensure that there is good
ventilation and that the outward flowing air is able to escape.
Do not cover ventilation
openings or grille.
Switching the appliance on and off
You are recommended to clean the interior of the appliance before
switching it on for the first time (see Cleaning).
Switching the appliance on
Connect the appliance to the mains - the appliance is switched on.
Important
Once the mains plug has been inserted, the refrigeration
unit may not come on until up to 8 minutes later. This is
required to protect the electronic controls.
Switching the appliance o
Pulloutthemainsplugorsetthetemperaturecontrol
to 0.
Important
When the temperature control is turned to "0", the refrig-
eration system is switched off, but the appliance is not
completely disconnected from the mains. Before cleaning,
always disconnect the appliance from the mains. Remove
the plug.
4

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Liebherr CMes 502 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Liebherr CMes 502 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,71 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Liebherr CMes 502

Liebherr CMes 502 Gebruiksaanwijzing - Nederlands - 5 pagina's

Liebherr CMes 502 Gebruiksaanwijzing - Deutsch - 5 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info