455819
11
Verklein
Vergroot
Pagina terug
1/13
Pagina verder
11
NOTES:
A.) The clock radio must be at room temperature for the WAVE SENSOR to function properly. If
the radio has been in a cold location the WAVE SENSOR may not operate immediately. Place
the radio in the room where it will be used, connect it to the AC outlet, and allow approximately
30 minutes to 60 minutes for the radio to come to room temperature before testing the WAVE
SENSOR function.
B.) If the dimmer switch is set to the OFF/WAVE position the display will be completely off.
However at the Alarm time the display will return to full brightness automatically. It will remain
at full brightness for one hour and then return to the ‘Off position. If you stop the alarm
immediately by pressing the respective Alarm 1 or Alarm 2 buttons, or set the Alarm 1 or Alarm
2 switches to their OFFpositions, or use the SNOOZE control, the display will return to the
‘Off’ position after 10 seconds.
Changing The Lithium Battery
Like all batteries, eventually the built in lithium battery will need to be replaced. A number of
factors, such as, the length of time between the date the radio was manufactured and the date you
plugged it in for the first time determine the amount of time before replacement. During this initial
storage period, the lithium battery is supplying power to the automatic time setting
computer
memory. Once you plug the radio in, your household outlet supplies the power, and the battery is
not being used. A fresh lithium battery can supply power to the automatic time setting system
computer for at least 3 years even if it is never connected to an AC power supply. If your radio was
connected to your AC supply within a few months after it was manufactured, and you experience
only the normal, nuisance type, short duration power interruptions, your battery may last for up to 5
years or even longer. When the battery power drops below a certain level, the LOW BATT.
Indicator will ‘Flash’. When you see this indicator, you should change the battery as soon as it is
convenient for you to do so. To change the batteries proceed as follows:
1.) Purchase a replacement 3V lithium battery wherever batteries are sold. The battery type is
CR2430 or CR2450.
2.) Remove the battery from its package so it is ready to install.
IMPORTANT: Leave the radio power cord connected to your AC outlet. This will provide power
to the automatic time setting
computer memory while the original lithium battery is removed.
3.) Turn the radio face up and use a small screwdriver to remove the screw securing the battery
holder to the cabinet.
BE CAREFUL NOT TO LOSE THIS SMALL SCREW!
4.) Remove the original battery from the holder and insert the new battery into the holder the same
way, observing the positive (+) direction. Slide the holder with the new battery back into the slot in
the cabinet.
5.) Replace the screw that secures the battery holder in the cabinet.
6.) Turn the radio right side up and confirm that the LOW BATT. indicator is ‘Off’.
7.) Save these instructions. You’ll have to do this again five to eight years from now!
Resetting The Clock After A Total Memory Loss
11

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Lenco-cr-334

Zoeken resetten

  • Mijn wekkerradio Lenco CR-334 springt 10 dagen eerder dan 26 maart naar zomertijd. Wat is daarvan de reden en kan dat aangepast worden? Gesteld op 25-3-2023 om 17:50

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Lenco cr 334 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Lenco cr 334 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,52 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Lenco cr 334

Lenco cr 334 Gebruiksaanwijzing - Nederlands - 12 pagina's

Lenco cr 334 Gebruiksaanwijzing - Deutsch - 13 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info