Programming
To access programming of the doses, use the right-hand push buttons as
follows. The left-hand push-buttons will be automatically programmed with the
same doses.
- Keep the key pressed for at least 5 seconds.Keep the key pressed for at least 5 seconds.
- All of the LED’s come on.All of the LED’s come on.
- Press the selection key to be programmed. The corresponding LED blinksPress the selection key to be programmed. The corresponding LED blinks
(e.g. ).
- The LED of the key remains on.The LED of the key remains on.
- The brew head’s pump and solenoid valve are enabled.The brew head’s pump and solenoid valve are enabled.
- When the desired amount has been dispensed, press the key again to stopWhen the desired amount has been dispensed, press the key again to stop
dispensing.
- Repeat these operations to program the other doses.Repeat these operations to program the other doses.
- To store the preset doses when programming is !nished, exit after a time-outTo store the preset doses when programming is !nished, exit after a time-out
of 30 seconds.
The electronic models are equipped with a electronic control unit.
By using a nextgeneration microprocessor where both program memory and
programmed data memory are contained in the same device, a very compact
product which is extremely immune to disturbances in the mains was created.the mains was created.
Periodic controlsPeriodic controls
- On a regular basis, i.e. every 15÷20 Kg of coffee, remember to regenerate theOn a regular basis, i.e. every 15÷20 Kg of coffee, remember to regenerate the
water softener system in order to remove any calcium salts deposited inside
(refer to the corresponding user’s booklet).
6. Use
