626738
2
Verklein
Vergroot
Pagina terug
1/20
Pagina verder
5
Weather forecasting function with 3 weather icons and weather tendency indicator
Dew point display in ºF/°C
Outdoor temperature display in ºF/°C
Outdoor Humidity display as RH%
Indoor temperature display in ºF/°C
Display MIN/MAX value of outdoor temperature, outdoor humidity, dew point, wind chill and
relative pressure with time and date of recording
Display MAX value of wind speed, gust and 24h rainfall
Low/High outdoor temperature and humidity alarm
Relative air pressure displayed in inHg or hPa
Air pressure tendency indicator for the past 12 hours (bar graph format)
LCD contrast selectable
Low battery indicator
Wind direction displayed in 16 steps
Wind speed and gust displayed in mph, km/h, or m/s
Wind speed displayed in Beaufort scale
Wind chill displayed in °F or °C
High alarm function for wind speed
Manual reset of outdoor temperature, outdoor humidity, dew point, wind chill, pressure,
wind speed, gust, 24h rainfall(does not always reset 24 hour) and total rainfall
24h rainfall display in inch or mm
Total rainfall display in inch or mm
Storm warning alarm
Buzzer on/off selectable
Storage of 140 sets of history weather data recorded in 3-hour intervals
Wireless transmission at 915 MHz
Transmission range up to 330 feet (100 meters)
6
Thermo-hygro Sensor
Remote transmission of the outdoor temperature and humidity to the
Weather Center at 915 MHz
Weather-resistant casing
Wall mounting case (to be mounted in a sheltered place. Avoid direct rain
and sunshine)
Wind Sensor
Connected to the thermo-hygro sensor by cable
Can be installed onto a mast or a horizontal panel
Rain Sensor
Remote transmission of the rainfall data to the Weather Center
at 915 MHz
To be mounted onto a horizontal panel
7
Cable connection between the wind
sensor and the thermo-hygro sensor
Wireless transmission
at 915 MHz - thermo-
hygro and rain sensor
to the Weather Center
Weather Center
Wind sensor
Rain senso
r
SETTING UP:
Note:
8
Sockets for wind sensor
When putting the Weather Center into operation, it is important to perform in close proximity (e.g.
on a table about 5 ft apart) a complete wiring and set-up of the system. This step is important to
test all components for correct function before placing and mounting them at their final
destinations (See Positioning below). Spin the wind vane and tip the rain gauge to test.
1. Unwind the cables of the Wind sensor. Connect the Wind sensor to the Thermo-hygro
transmitter by plugging the connector head into the socket of the Thermo-hygro sensor.
Cord should “click” into place.
2. First insert the batteries into the Thermo-hygro sensor and Rain sensor “How to install
and replace the batteries into the Thermo-hygro sensor“ and “How to install and
replace the batteries into the Rain sensor” below).
3. Then insert the batteries into the Weather Center (see “How to install and replace the
batteries into the Weather Center below). Once the batteries are installed, all segments
of the LCD will light up briefly and a short signal tone will be heard. It will then display the
time as 12:00, the date as 1.1.05, the weather icons, and air pressure value. "- - -" will be
shown for outdoor data.
2

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw La Crosse WS-1516-IT bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van La Crosse WS-1516-IT in de taal/talen: Engels als bijlage per email.

De handleiding is 0,52 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info