639537
86
Verklein
Vergroot
Pagina terug
1/88
Pagina verder
70 STORAGE
STORAGE
To avoid personal injury:
A Do not clean the machine while the engine is
running.
A To avoid the danger of exhaust fume
poisoning, do not operate the engine in a
closed building without proper ventilation.
A When storing, remove the key from the key
switch to avoid unauthorized persons from
operating the tractor and getting injured.
TRACTOR STORAGE
If you intend to store your tractor for an extended period
of time, follow the procedures outlined below.
These procedures will insure that the tractor is ready to
operate with minimum preparation when it is removed
from storage.
1. Check the bolts and nuts for looseness, and tighten if
necessary.
2. Apply grease to tractor areas where bare metal will
rust also to pivot areas.
3. Detach the weights from the tractor body.
4. Inflate the tires to a pressure a little higher than usual.
5. Change the engine oil and run the engine to circulate
oil throughout the engine block and internal moving
parts for about five minutes.
6. Keep the clutch disengaged. If the clutch is left
engaged for a long period of time, the clutch plate may
rust, making clutch disengagement impossible at the
next operation.
7. With all implements lowered to the ground, coat any
exposed hydraulic cylinder piston rods with grease.
8. Remove the battery from the tractor. Store the battery
following the battery storage procedures.
(See "Battery" in "EVERY 100 HOURS" in "PERIODIC
SERVICE" section.)
9. Keep the tractor in a dry place where the tractor is
sheltered from the elements. Cover the tractor.
10.Store the tractor indoors in a dry area that is protected
from sunlight and excessive heat. If the tractor must be
stored outdoors, cover it with a waterproof tarpaulin.
Jack the tractor up and place blocks under the front
and rear axles so that all four tires are off the ground.
Keep the tires out of direct sunlight and extreme heat.
A When washing the tractor, be sure to stop the engine.
Allow sufficient time for the engine to cool before
washing.
A Cover the tractor after the muffler and the engine have
cooled down.
REMOVING THE TRACTOR FROM
STORAGE
1. Check the tire air pressure and inflate the tires if they
are low.
2. Jack the tractor up and remove the support blocks
from under the front and rear axles.
3. Install the battery. Before installing the battery, be sure
it is fully charged.
4. Check the fan belt tension.
5. Check all fluid levels (engine oil, transmission/
hydraulic oil, engine coolant and any attached
implements).
6. Start the engine. Observe all gauges. If all gauges are
functioning properly and reading normal, move the
tractor outside. Once outside, park the tractor and let
the engine idle for at least five minutes. Shut the
engine off and walk around tractor and make a visual
inspection looking for evidence of oil or water leaks.
7. With the engine fully warmed up, release the parking
brake and test the brakes for proper adjustment as you
move forward. Adjust the brakes as necessary.
(1) Wooden block
86

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Kubota B2320 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Kubota B2320 in de taal/talen: Engels als bijlage per email.

De handleiding is 5,46 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info