668620
2
Verklein
Vergroot
Pagina terug
1/6
Pagina verder
If you then press the BEAT/TAP [] or [] switch to enter Beat
mode, the metronome will begin sounding at the displayed
tempo.
If the BPM detected by the Tap Tempo function is less than 40,
the display will indicate “Lo”. If you then enter Beat mode, the
tempo will be set to “40” bpm.
If the BPM detected by the Tap Tempo function is greater than
208, the display will indicate “Hi”. If you then enter Beat mode,
the tempo will be set to “208” bpm.
4 Play along with the metronome tempo.
Using the tuner and metronome simultaneously
The TM-40 lets you use the tuner and metronome simultaneously.
For details on tuner operation and metronome operation, refer to
“Using the tuner” and “Using the metronome.”
Using the tuner and metronome simultaneously
For example if you're playing along with the metronome and notice
that your instrument is not tuned correctly, you can leave the
metronome running while you tune.
Proceed as follows.
1 Press the [METRONOME ON] switch.
In Beat mode
Press the [START/STOP–TAP IN] switch to start the metronome.
If necessary, specify the tempo and time signature etc.
To set the tempo: TEMPO [] or [] switch
To set the time signature: BEAT/TAP [] or [] switch
When using the tuner and metronome simultaneously, you
can't select “triplets”, “triplets without the center beat”,
“quadruplets” or “quadruplets without the center beats” as
the time signature.
In Tap mode
Simultaneously press the BEAT/TAP [] and [] switches to
enter Tap mode, and use the [START/STOP-TAP IN] switch to
input the tap tempo.
Then press the BEAT/TAP [] or [] switch to enter Beat mode;
the metronome will start.
If necessary, use Beat mode to adjust the tempo and time
signature.
2 Press the [TUNER ON] switch to enter Meter mode.
The display will show the tuning meter. In this state, the tempo
is indicated by the LEDs located at the left and right of the
display.
If you want to tune in Sound Out mode, you should then press
the [SOUND] switch.
Adjust the calibration if necessary.
To adjust the calibration: CALIB [] or [] switch
Tuning in Meter mode
When you play a single note on your instrument, the display
will show the name of the note that is closest to the pitch you
played. Tune your instrument while watching the meter and the
tuning guide.
Tuning in Sound Out mode
Press the [SOUND] switch to select the name of the desired note.
Tune your instrument to the pitch you hear.
3 When you're finished tuning, press the [TUNER ON] switch.
Specifications
Tuner section
Scale: 12 note equal temperament
Detection range*: C1 (32.70 Hz)–C8 (4186.01 Hz) for a
sinewave
Reference tone: C4 (261.63 Hz)–C5 (523.25 Hz) One octave
or AB
Tuning modes: Meter mode (AUTO)
Sound Out mode (MANUAL)
Calibration range: A4 = 410 Hz–480 Hz (1 Hz step)
Detection accuracy: Better than ±1 cent
Sound accuracy: Better than ±1 cent
Metronome section
Tempo range: 40–208 beats per minute (bpm)
Tempo setting: PENDULUM STEP
FULL STEP
Time signatures: 0–7 beats, duplets, triplets, triplets,
without the center beat, quadruplets,
quadruplets without the center beats
Tempo accuracy: ±0.3%
Metronome modes: Beat modem
Tap mode
Connectors: INPUT jack (1/4”mono)
PHONE jack (1/8” mini)
Speaker: Dynamic speaker (ø28 mm)
Power supply: Two AAA batteries (3V)
Battery life: Tuner ... Approximately 70 hours (A4 continuous
input, when using zinc-carbon batteries)
Metronome ... approximately 50 hours (tempo 120,
four beats, maximum volume, when using zinc-
carbon batteries)
Dimensions: 133 (W) x 77 (D) x 18 (H) mm /
5.24” (W) x 3.03” (D) x 0.71” (H)
Weight: 87 g (107 g, including batteries) /
3.07 oz. (3.77 oz., including batteries)
Included items:
Owner's manual, two AAA batteries for checking
operation
The Calibration setting and Sound setting (“12 NOTES
” or “AB
”) of the
Tuner section are remembered even when the power is off. However when
you exchange the batteries, these settings will return to the following default
values.
Default values: Calibration = 440 Hz, Sound = 12 NOTES
The tempo, Time signature, and Tempo setting type (“PENDULUM STEP” or
“FULL STEP”) of the Metronome section are remembered even when the
power is off. However when you exchange the batteries, these settings will
return to the following default values.
Default values: Tempo = 120, Time signature = four beats, Tempo setting
type = PENDULUM STEP
* Even if the pitch is within the range of detection, the TM-40 may be unable to
detect the pitch if the sound contains numerous overtones (such as the low and
high notes on an acoustic piano) or if the instrument has a rapid decay.
Specifications and appearance are subject to change without notice for improve-
ment.
3 If you want to change the calibration setting, press the CALIB
[] or [] switch. This setting is remembered even when the
power is off.
Press the CALIB [] or [] switch: The calibration setting
will increase or decrease in 1 Hz steps. If you hold down the
switch, the calibration setting will change continuously.
4 Play a single note on your instrument.
The name of the note closest to the note you played will appear
in the left of the display. Tune your instrument to the correct
pitch, so that the desired note name appears.
If you're using the internal mic, place your instrument as
close as possible to the mic so that extraneous sound is not
picked up while tuning.
5 While playing a single note on your instrument, tune your
instrument so that the tip of the meter indicates “0” and the
center indicator of the tuning guide is lit.
The left tuning guide indicator will light if the pitch of your
instrument is flat, and the right indicator if the pitch is sharp.
6 If you want to tune a just major third above or a minor third
above a certain note, use the “
” (-13.7 cent) or “ ” (+15.6 cent)
marks on the meter.
Tuning to a just major third above or a minor third above
If you want to tune to a just major third above A (0 cent), tune
your instrument so that the note name indicator shows C# and
the meter is at “
”.
If you want to tune to a minor third above A (0 cent), tune your
instrument so that the note name indicator shows C and the
meter is at “
”.
Tuning to a reference tone (Sound Out mode)
1 Press the [TUNER ON] switch.
You will enter the Meter mode.
2 Press the [SOUND] switch to select Sound Out mode.
When you enter Sound Out mode, the speaker will produce
sound.
Use the volume control to adjust the speaker volume.
3 If you want to change the calibration setting, press the CALIB
[] or [] switch.
4 Press the [SOUND] switch to select the desired reference pitch.
By pressing and holding down the [SOUND] switch for approxi-
mately one second, you can switch between “12 NOTES” or
“AB
.” This setting is remembered even when the power is off.
Now you can press the [SOUND] switch to choose the following
settings for “12 NOTES” or “AB
”.
12 NOTES: C (C4) C# D E
E F F# G G#
A B
B C (C5) no display (Meter mode) C (C4)...
AB
: A (A4) B
(B
4) no display (Meter mode) A (A4)...
5 Tune your instrument to the reference pitch.
Using the metronome
Setting the tempo and time signature (Beat mode)
1 Press the [METRONOME ON] switch.
You will enter Beat mode, and the metronome pendulum will
appear in the display. The upper part of the display will indicate
“METRONOME.”
2 Press the TEMPO [] or [] switch to set the tempo.
By pressing and holding down both TEMPO [] and []
switches for approximately one second, you can switch between
“PENDULUM STEP” and “FULL STEP”. The setting will
alternate each time you hold down the switches for approxi-
mately one second.
After selecting “PENDULUM STEP” or “FULL STEP”, press the
TEMPO [] or [] switch to set the tempo. This setting is
remembered even when the power is off.
If you've selected “PENDULUM STEP”
Pressing the TEMPO [] or [] switch will increase or decrease
the tempo value in the steps shown below. The value will
change continuously if you hold down the switch.
Press the TEMPO [] or [] switch: ÷ 40 ÷ 42 ÷ 44... 88 ÷
92 ÷ 96 ... 192 ÷ 200 ÷ 208 ÷ 40...
If you've selected “FULL STEP”
Pressing the TEMPO [] or [] switch will increase or decrease
the tempo value in steps of 1 bpm as shown below. The value
will change continuously if you hold down the switch.
Press the TEMPO [] or [] switch: ÷ 40 ÷ 41 ÷ 42... 206 ÷
207 ÷ 208 ÷ 40 ...
3 Press the [START/STOP–TAP IN] switch to start the metronome.
The metronome pendulum will swing
between left to right at the specified
tempo, and the LEDs at left and right
of the display will also light alternately
in synchronization with the tempo.
4 If you want to change the time signature, press the BEAT/TAP
[] or [] switch to make your selection. The time signature
will change as follows.
Press the BEAT/TAP [] or [] switch: ÷ 0 ÷ 1...7 (7 beats) ÷
(duplets) ÷ (triplets) ÷ (triplets without the center
beat) ÷
(quadruplets) ÷ (quadruplets without the
center beats) ÷ 0...
5 Play along with the metronome tempo.
6 To stop the metronome, press the [START/STOP–TAP IN]
switch.
Inputting tap tempo (Tap mode)
The tap tempo you input will be displayed as a BPM (Beats Per
Minute) value.
1 Press the [METRONOME ON] switch.
You will enter the Beat mode.
2 Simultaneously press the BEAT/TAP [] and [] switches to
enter Tap mode.
“TAP” will appear at the left of the “TEMPO” indicator on the
display.
3 Press the [START/STOP–TAP IN] switch several times at regular
intervals.
The TM-40 detects the interval at which you pressed the switch,
displays it as a BPM (Beats Per Minute) value, and sets it as the
tempo. The display will indicate the value.
2

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Korg TM40 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Korg TM40 in de taal/talen: Duits, Engels, Frans als bijlage per email.

De handleiding is 0,64 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info