584729
3
Verklein
Vergroot
Pagina terug
1/8
Pagina verder
Connecting
• Your loudspeakers are equipped with positive (Red) and negative
(Black) connection terminals on the rear of the cabinet. These
correspond to the positive and negative terminals on the
appropriate channel (left, right, center, rear etc.) of your amplifier.
3
Center Channel Speaker (See Figures 2A and 2B.)
• Place immediately above or below the center of your video display.
Surround Channel Speakers (See Figures 2A, 2B and 3.)
• Place above seated ear height on side or rear walls
(approximately 4-5 feet above the floor).
• Use the attached wall brackets to hook to appropriately sized
screw heads screwed into a wall stud and wall anchor or two
wall anchors with a suitable weight bearing capacity. (See
Figure 3.)
Never use the wall bracket for mounting the speaker to
the ceiling.
On Wall Placement
• Klipsch Icon bookshelf models may be wall-mounted using
the
1
/
4
-20 threaded insert on the rear of the speaker. Be sure
the mounting hardware you are using has the necessary load
bearing capabilities before hanging any speaker. If you use
a bracket, see the bracket owners manual for mounting details.
Turn your amplifier off before making any
connections.
Standard Connections (See Figure 4.)(All Models)
• All speakers in your system must be connected in phase with
the positive speaker terminal connected to the positive
amplifier terminal. Repeat this for the negative speaker
terminal and amplifier terminals. Most speaker wire has
distinguishing markings on the insulation of one of the
conductors to assist in correct hookup.
• Use 16 gauge (AWG), two conductor, copper wire at a
minimum and larger gauge wire for longer runs. The
connection terminals on your loudspeaker will accommodate
bare wire, spade terminals, and banana plugs.
With all connection types, take care that there is no
contact between the positive and negative terminals
at the speaker and amplifier. Damage to your equipment
may result.
WF-35 and WF-34 Standard Connections
• Use either pair of positive and negative terminals keeping the
metal coupling straps in place.
Bi-Wire Connections (See Figure 5.)
• The WF-35 and WF-34 are equipped with two pair of
connection terminals for bi-wire hookup and enhanced
performance.
• Remove the metal coupling straps.
• Connect one speaker wire (+ and -)to the top pair of binding
posts and a second speaker wire (+ and -) to the bottom pair
of binding posts.
Care and Cleaning
• Occasional dusting or wiping of the cabinet with a cloth
is all that is required. Never use abrasive or solvent type
cleaners or harsh detergents.
• A vacuum cleaner with a soft brush attachment may be used
to clean the grille fabric.
• Never spray polishes or cleaners on the drive units (woofers,
midranges or tweeters).
Bass Management
When using your speakers in a home theater system, consult
the owner’s manual of your surround electronics for proper
application of bass management settings.
• As a general rule, compact speakers (Bookshelf, Center
Channel and Surrounds) are set to the “Small,” or bass-
limited setting.
• Floorstanding speakers are typically set to the “Large,” or
full-range setting.
• Also refer to the electronics instructions for adjusting the
relative volume levels of the speakers so they are at the same
level when listened to from the primary listening position.
3

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Klipsch Icon Series W bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Klipsch Icon Series W in de taal/talen: Engels als bijlage per email.

De handleiding is 0,66 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info