828428
16
Verklein
Vergroot
Pagina terug
1/17
Pagina verder
29 30
Storage
1. Disconnect the device from the mains by pulling out the mains plug and
bundling the mains cable to avoid damage. This can be wound up on the
back of the device.
2. Loosen the square exhaust connection so that the exhaust hose is not
connected to the device.
3. Empty the water tank and leave at least one of the drain plugs open.
4. Only keep the device upright in a well-ventilated place (standing - never
lying down) and avoid direct sunlight.
Note
If you have any questions or are unclear, please contact the KLAMER Customer Support
Team at [email protected]. We're here to help!
Cleaning and care
Please always unplug the device from the power source before beginning any
cleaning or component replacement.
Cleaning the case
Generally wipe the air conditioner with a dry and soft cloth. To remove heavy
dirt, clean the device with a damp cloth. However, never use aggressive
cleaning agents, especially not for the controls (touch buttons and display).
Please do not use liquid cleaners such as gasoline (even in diluted form) or
chemical cleaning cloths to avoid deformation or cracking of the case.
Problem solving
Problem Possible cause Solution
The air conditioning doesn't
turn on
The display shows E4
The device has no power Connect the device to a
power source
The water tank is full Empty the water tank as
described on page 28
The start protection is active Wait at least 3 minutes and
try again
Problem solving
Problem Possible cause Solution
HI is shown on the display
The set target temperature
has been reached
This is normal, you don't
need to do anything
The display shows E2 or E3 The device is defect Contact KLAMER customer
service
The temperature protection
has activated to prevent
damage to the device due
to excessive temperatures
Lower the ambient
temperature to less than
43°C for the device to
continue operating
LO is shown on the display The temperature protection
has activated to prevent
damage to the device due
to low temperature
Increase the ambient
temperature to more than
15°C for the device to
continue operating
The remote control batteries
are empty
Replace the batteries with
fully charged ones
The air conditioner does not
cool enough
The room temperature is
lower than the temperature
measured by the air
conditioner sensor
Lower the ambient
temperature to less than
43°C for the device to
continue operating
The device switches off or
stops cooling
The set TIMER time has
expired
This is normal, you don't
need to do anything
16

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Klamer 20 - 91674 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Klamer 20 - 91674 in de taal/talen: Duits, Engels als bijlage per email.

De handleiding is 12,69 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info