F2 Drum Mixer:
This is used to disable the control of the parameters of Drum On/Off, Drum Volume, Drum Reverb, Drum Pan, Manual Drum
F3 Keyb&Util 1/2:This is used to disable the control of the parameters of Octave, Portamento, Harmony, Pianist, Vocalizer, 2
nd
Sustain, 2
nd
Split, Velocity Curve, Rotor Wheel
F3 Keyb&Util 2/2:
This is used to disable the control of the parameters of Accordion, Modulation Assign, Modulation Rate, Tune, Vibrato,
Portamento Time, Bend Parameter, Footswitch, Arabic Menu, Arabic Mode
F4 Eff&Micro:
This is used to disable the control of the parameters of Global Reverb, Right Reverb, Reverb Type, Chorus Type, Delay Type,
Distortor Type, Microphone Parameter
F5 Arrange 1/4: This is used to disable the control of the parameters of Jump Intro, Jump Fill, Manual Bass, To Root, To Lowest, Lock, Split,
Interactive On/Off, Interactive Mode
F5 Arrange 2/4: This is used to disable the control of the parameters of Program Change, Volume, Reverb, Effect, Pan Pot
F5 Arrange 3/4: This is used to disable the control of the parameters of Lower Hold, Lower Mute, Lower Mode, Bass Sustain, Bass Mono/Poly,
Bass Boost, Bass Octave, Pedal Board, Bass To Pedal, 4Switch Mode
F5 Arrange 4/4: This is used to disable the control of the parameters of Bass Lock, Lower Lock, Step Tempo, Sync Time, Chord Mode
F6 Tabs: This is used to inhibit the control of the enabling status of the push buttons on the control panel relevant to 2
nd
Voice, 1
Touch, Key Start and Key Stop.
F7 Save: This is used to save the settings made in the Flash RAM. These settings are stored even after the instrument has been turned
off and are called up when it is turned on again.
F8 Default: This resets the original control status of all the parameters.
F9 Auto Switch: When it is enabled (On) it disables the REG. push button (LED will go off) after having selected the Registration to allow the
user to select a Style with the numeric keypad.
F10 Select: Once the parameter has been selected F10 Select is used to modify its enabling status.
Note: All Registers store the values of the above parameters, however, there are some parameters (e.g. SPLIT, Foot Switch assignment) which
the user might not want to change while they change from one Register to another. This is where the above feature becomes useful permitting
the ability to ‘freeze’ certain features that need not change as you change from one Register to anther!
XD9-XD3
72
Registrations
