473137
16
Verklein
Vergroot
Pagina terug
1/20
Pagina verder
KTF-3010/KTF-2010 (En)
16
Do not use contact cleaners because it could cause a malfunction. Be specially careful against contact cleaners containing oil, for they may
deform the plastic components.
Note
Note
Operation to reset
The microcomputer may fall into malfunction (impossibility to
operate, erroneous display, etc.) when the power cord is unplugged
while power is ON or due to an external factor. In this case, ex-
ecute the following procedure to reset the microcomputer and
return it to normal condition.
Unplug the power cord from the power socket and, while
holding the ON/STANDBY key depressed, plug the power
cord into the socket again.
÷ Please note that resetting the microcomputer clears the contents
stored in it and returns it to the condition when it left the factory.
Symptom Cause Remedy
÷ Use audio cords to connect the tuner to the
amplifier.
4
÷ Connect an antenna. 5
÷ Set the broadcast band properly. 8
÷ Tune the frequency of the desired station.
8
÷ Set the ANT A/B key properly.
(KTF-3010 only).
7
÷ If located far from the broadcast station, in-
stall a dedicated FM outdoor antenna (5–6
elements).
÷ Preset the desired station.
0
÷ Preset the station again. 0
÷ Install the outdoor antenna away from the
road.
÷ Turn off the power of the appliance.
÷
Install the system further apart from the TV set.
÷
Install the system further apart from the PC.
÷ Set the IF BAND to WIDE. 7
÷ The tuner is not connected to the amplifier.
÷ No antenna is connected.
÷ The broadcast band is not set properly.
÷ The frequency of the desired station is not
tuned.
÷ The ANT A/B key is not set properly
(KTF-3010 only).
÷ The signal detected by the antenna is weak.
÷ No station is preset in the recalled channel.
÷ The preset memory was cleared because the
power cord had been unplugged for a long
period of time.
÷ Noise due to ignition noise of an automobile.
÷ Noise due to an influence from an electric
appliance.
÷ Noise due to a nearby TV set.
÷ There is a PC nearby.
÷ The broadcasted sound level is too high.
No sound is heard.
Radio stations cannot be received.
No station is received when a numeric key
pressed.
Interference.
Sound is distorted when the IF BAND is set
to NARROW (KTF-3010 only).
When the amplifier and the tuner are connected with the system control cord 4
Even if the input selector of the amplifier is connected to the source other than the tuner, the input selector of the amplifier switches to the
tuner when the desired program starts in the EON reservation mode.
Combined with the [SL16], the input selector returns to the original source after the desired program finishes, however, with a [XS8] it will not.
What appears to be a malfunction may not always be serious. If your unit should not perform as expected, consult the table below to see if the
problem can be corrected before seeking help from your dealer or service representative.
In case of difficulty
16

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Kenwood KTF 3010-2010 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Kenwood KTF 3010-2010 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,29 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info