633366
14
Verklein
Vergroot
Pagina terug
1/16
Pagina verder
14
KAF-3010R/1010 (En)
In case of difficulty
NoteNote
Note
Do not use contact cleaners because it could cause a malfunction. Be specially careful against contact cleaners containing oil, for
they may deform the plastic components.
Operation to reset
The microcomputer may fall into malfunction (impossibility to
operate, erroneous display, etc.) when the power cord is un-
plugged while power is ON or due to an external factor. In this
case, execute the following procedure to reset the microcom-
puter and return it to normal condition.
Set the POWER to OFF then, while holding down the SOURCE
DIRECT key, set the POWER switch to ON.
Symptom
Remote control unit (KAF-3010R only)
Cause Remedy
Batteries are exhausted.
The remote control unit is too far away
from the main system, controlling angle is
too large, or there is an obstacle in be-
tween.
The audio cords and system control cords
are not connected properly.
The source component to be operated
does not contain the tape(s) or CD.
The POWER switch is set to OFF.
Remote control operation is not possible
Replace with new batteries. 9
Operate the remote control unit within the
controllable range.
9
Connect properly referring to “System
connection”.
45
Place the tape(s) or CD in the source com-
ponent to be played.
Set the POWER switch to ON. 0
Speaker protection circuit
When this unit’s power is turned ON with the speaker cable short-circuited, the speaker protection functions.
If the standby indicator blinks (KAF-3010R) or the MUTING indicator blinks (KAF-1010) and no sound occurs, turn the power
OFF, remove the short-circuit, then turn the power ON again.
Please note that resetting the microcomputer clears the contents
stored in it and returns it to the condition when it left the factory.
The speaker cords are disconnected.
The VOLUME CONTROL is set to the
minimum position.
MUTING is ON.
(The MUTING indicator is blinking)
The SPEAKERS switches are set to OFF.
The system control cords are not fully con-
nected.
Speaker cords are short-circuited.
The speaker cord is disconnected.
The BALANCE control is set to an extreme
position.
Symptom
Cause Remedy
Connect them properly referring to “Sys-
tem connection”.
6
Adjust the volume to a proper level.0
Press the MUTING key to OFF. !
Set the SPEAKERS switch(es) to ON.
0
Check the system control connections.
45
Turn the power off, eliminate the short-cir-
cuiting, then turn on the power again.
Connect it properly referring to “System
connection”.
6
Adjust the Left/Right balance. !
Sound is not output.
The standby indicator blinks and sound
is not output. (KAF-3010R)
The MUTING indicator blinks and sound
is not output. (KAF-1010)
Sound is not output from one of the
speakers.
Amplifier
What appears to be a malfunction may not always be serious. If your unit should not perform as expected, consult the table below
to see if the problem can be corrected before seeking help from your dealer or service representative.
14

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Kenwood KAF-1010 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Kenwood KAF-1010 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,5 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info