522398
5
Verklein
Vergroot
Pagina terug
1/8
Pagina verder
For use without the weight. The prefilter is functional with or without the weight (we rec-
ommend using with the weight). To use without the weight, remove the strainer barb from
the input hose. Re-assemble without the weight.
4. Storage: Your Katadyn water system comes with a carry bag for storage. To prevent the
possibility of cross contamination, remove the output hose and EasyFill Bottle Adaptor and
store separately in a re-sealable bag inside the carry bag.
LONG-TERM STORAGE (AFTER YOUR TRIP IS OVER)
Disinfect your microfilter before storage to prevent microbiological growth within the pump.
1. Fill a liter container with tap water and add 2 tablets of Micropur Forte DCCNa or
Micropur MP1. (Do not use Micropur Classic.)
2. Place prefilter into solution.
3. Pump entire amount of solution through unit (into sink or container).
4. Remove prefilter from the solution and continue pumping another 5 to 10 strokes to remove
remaining water from the pump body and hoses.
5. Remove cartridge and allow to dry.
6. Wrap hoses around body and store in carry bag.
Note: When removing unit from long-term storage, flush the system with one liter of water to
remove any stale tasting water.
CARTRIDGE CAPACITY
Cartridge capacity depends on water quality. The Katadyn Hiker Pro was tested at 750 liters
(without filter protector) and found effective for removal of bacteria (Klebsiella terrigena) and pro-
tozoan cysts (Giardia and Cryptosporidium). For maximum performance, cartridge should be
replaced after 750 liters or when the unit becomes hard to pump.
CARTRIDGE INSTALLATION
Replacement cartridges are available from the dealer where you purchased your Hiker Pro.
1. Remove output hose from cartridge output barb. Grasp the top of the Hiker Pro cartridge
and turn counter clockwise. If cartridge removal is not possible by hand, the handle shaft
will function as a cartridge removal tool:
Remove the handle collar and handle. Locate one of the deep grooves on either side of the
handle shaft. Lay the handle across the filter top and insert two of the “fins” on top of the
filter into one of the groves of the handle shaft. Hold the handle shaft in place firmly with
the palm of your hand. Using the handle shaft for leverage, apply even pressure and grad-
ually turn the cartridge counter clockwise. Use caution so that handle shaft does not slip and
cause damage. Discard used cartridge in trash receptacle.
2. Rinse inside of housing by swishing with clear water (non-filtered water is ok). Discard water.
Wipe inside of housing and housing threads with soft cloth to remove sediment.
3. Remove new cartridge from packaging.
4. Insert new cartridge into housing and tighten clockwise. Note - Apply silicone lubricant to
cartridge o-ring before re-assembly to ease cartridge removal in the future.
5. Re-attach output hose to cartridge output barb. (Figure 1-1)
6. Flush cartridge by pumping and discarding the first liter.
EN 
5

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Katadyn Hiker Pro Water Microfilter bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Katadyn Hiker Pro Water Microfilter in de taal/talen: Engels als bijlage per email.

De handleiding is 1,16 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Andere handleiding(en) van Katadyn Hiker Pro Water Microfilter

Katadyn Hiker Pro Water Microfilter Gebruiksaanwijzing - Nederlands - 8 pagina's

Katadyn Hiker Pro Water Microfilter Gebruiksaanwijzing - Deutsch - 8 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info