-This appliance lets off steam that can cause burns. Never aim the steam jet at animals or
persons, and never let steam out over garments that are actually being worn and in contact
with the body. The hot steam release must be market by the following symbol:
-Please ensure that your hands are dry and that you have footwear on before plugging in the
cleaner to the mains electricity.
-Never add anti-oxidants, or alcohol, or any other product that is not specifically recommended
for the appliance, since these may cause damage to the tank.
-Change the nozzles and the accessories when these have cooled down, and with the appliance
disconnected.
-Never overfill the tank since this could cause excess steam pressure.
WARNING: Unplug the appliance in the following cases:
-When you are going to refill the appliance.
-Whilst you change the accessories that you are going to use after having waited for the
appliance to have cooled down sufficiently.
-When you finish using it.
-When there is an electricity cut.
INSTRUCTIONS FOR USE
-Put the steam cleaner on a flat surface, push down and unscrew the safety cap and put the
funnel in place.
-Pour 175ml of clean water in the filler vessel and add the water to the cleaner tank. (The
maximum capacity of the tank is 300ml. Do not exceed this capacity as there should be empty
space in the tank). Put the safety cap back in its place.
-Connect the appliance to the mains electricity. The pilot light will light up.
-After about 6 minutes, the steam will be ready. When this happens, press the steam
pushbutton and check that the steam is spraying out properly through the nozzle.
-Install the accessories you need, but do this always with the appliance disconnected from the
mains electricity, after having checked this, being very careful not to spray steam at the same
time by not pressing on the steam pushbutton.
-Press the steam pushbutton once again to start up the operations that you wish to carry out.
-In order to disinfect and sterilise, insert the long nozzle in the short nozzle and point it towards
the area to be sterilised; then press the steam button.
FILLING OF THE TANK WHILST OPERATING
-Disconnect the plug from the mains electricity supply.
-Press the steam pushbutton to release the pressure until no steam whatsoever is coming out.
-Very slowly unscrew the safety cap, but do not remove it since there still may be steam inside.
The cap therefore must be left in place until all the steam has been released.
-If the cap cannot be unscrewed because it is ``cross threaded´´, this means that the pressure
inside the tank is very high; in order to unscrew the cap the steam button should be pressed,
as many times as required, in order to eliminate all the steam and then be able to unscrew the
cap.
-When all the steam has been released, place the cleaner on a cold surface for around five
minutes for it to cool down. Now the safety cap can be removed.
-Use the funnel and the filler vessel to top up the water tank with the amount of water
necessary.
-Replace the safety cap on the cleaner and screw it right down in its position.
CLEANING AND STORAGE
-After having used the steam cleaner, disconnect the plug from the mains electricity supply.
-Press the steam pushbutton until all the pressure has been released and also all the steam
from the inside.
-When all the steam has been released, place the cleaner on a cold surface for around five
minutes for it to cool down. Now the safety cap can be removed.
-Empty any water that may be left in the tank and clean the outside surface with a dry cloth.
-Replace the safety cap on the cleaner and screw it right down in its position.
-Never immerse the appliance in water or under the faucet.
