554857
1
Verklein
Vergroot
Pagina terug
1/1
Pagina verder
RC-86 wireless keyfob
The RC-86 is a component of Jablotron’s OASiS 8x series alarm systems. It is designed to
remotely control setting/unsetting, trigger panic alarms, and control other appliances. The big
advantage is the possibility of configuring it to 433 MHz (JA-60 systems, UC-216, UC-222
receivers etc). The keyfob indicates its flat battery. A two button version of the case is also
available. Contact your dealer.
Enrolling to an Oasis control panel
A pair (left or right side) of the keyfob buttons can be enrolled to a control panel by pressing and
holding both buttons. See the OASiS control panel installation manual for more details.
If you wish to remove the keyfob from the system, erase it from its address in the control panel.
The natural reaction of the pair of buttons is setting and unsetting for each button respectively,
and panic alarm triggering by pressing both buttons together. If a reaction other than natural is
assigned, the reaction will only be triggered by buttons
or (according to which pair was
enrolled).
If you enroll both pairs of buttons to two different addresses in the control panel, then different
reactions and sections can be assigned to each pair of buttons. Then, for example, one pair could
set/unset the complete system, and the other pair could be used for partial setting.
Remaining buttons can be used to control another device such as e.g. a Jablotron car alarm, or
UC-8x and AC-8x receivers, UC-216, UC-222 …
Locking the keyfob
If four buttons version of the keyfob is used, keys can be locked or unlocked by pressing a
diagonal button pair (
+ or + ). When the keys are locked, the keyfob LED flashes rapidly
if any button is pressed (no signals are sent under these conditions). See the Keyfob configuration
chapter.
Panic alarms
Panic alarms can be triggered when buttons +
or
+
are pressed simultaneously. The keyfob
can be set so that a panic alarm is triggered when any one button on the keyfob’s left side (even
or )
is pressed. See the Keyfob configuration chapter.
Using with other products
In addition to Oasis control panels, the keyfob can also be used with other Jablotron products that
communicate via Oasis protocol. Examples are relay receivers type UC-8x and AC-8x. Guidance
on using the keyfobs can be found in the manual of the desired receiver.
If you want to use the keyfob for 433 MHz a pair of keys can be switched to this mode. See the
configuration chapter.
Keyfob configuration
1. Press and hold
.
The keyfob flashes
once and after a while starts to light
continuously.
2. Keep
pressed while pressing
x-
times according to the table below.
3. Then release
to end configuration
mode.
4. As confirmation, the LED flashes the
same number of times as you pressed
the
button.
The default mode is 5: No lock - unlock
possible, no one-button PANIC possible,
both pairs are 868MHz
Battery replacement
Indication of a flat battery is provided by
the keyfob LED. After any button is pressed
the LED flashes long (as usual) and then
briefly flashes twice as an indication of a flat
battery. The keyfob works as usual, it’s just that the working range of the keyfob could be reduced.
This indication is also done on the control panel (on its keypad or communicator). The indication is
cancelled when a new battery is inserted (L1016 type).
Expired batteries should not be thrown into the garbage, but disposed of according to local regulations.
Technical parameters
Voltage: alkaline battery type L1016 (6.0 V)
(Power Supply type C acc.to EN 50131-6)
Typical battery lifetime approx. 3 years (5 daily activations)
Communication band: 868 MHz/433MHz
Communication range approx. 30 metres (open area)
Op. environment acc. to EN 50131-1 II. indoor general
Operational temperature range -10 to +40 °C
Security grade acc.to EN 50131-1 2
Can be operated according to ERC REC 70-03
Complies with ETSI EN 300220,EN 55022, EN 50134-2, EN50130-4, EN60950-1
JABLOTRON ALARMS hereby declares that the RC-86 is in compliance with the essential requirements
and other relevant provisions of Directive 1999/5/EC.. The original of the conformity assessment can be
found at www.jablotron.com, Technical Support section.
Note: Although this product does not contain any harmful materials we suggest you return the product to the
dealer or directly to the producer after use.
MGE53602
function
mode
x
pressed
keyfob
lock
or
PANIC
433MHz
433MHz
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Jablotron-RC-86

Zoeken resetten

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Jablotron RC-86 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Jablotron RC-86 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,03 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info