554867
2
Verklein
Vergroot
Pagina terug
1/4
Pagina verder
JK-06 PROFI TEL KIT 2/4 MGK55107
4. Detectors and accessories installation
a) Install the JA-60N magnetic detector to the door (antenna
pointing up or down)
b) Install the JA-60P motion PIR detector
A
attach
C
open
B
click
rear tamper
lever
Don't tight
this screw
2
2,5
1,5
1
0,5
1,6 3,7
12
range
[m]
height
[m]
120
ş
1
2
m
zone A
zone B
zone C
zone A
zone B
zone C
JA-60P coverage
avoid location against windows or close to a heater
c) Select Instant or Delay reactions via DIP switches inside
the detectors.
d) Connect detector’s batteries (pull out the red tape to
activate the batteries)
e) Attach the keypad to the desired location
f) Plug in the UC-260 wireless siren into a power socket
5. Enrollment of additional accessories
If you install additional detectors (max. 32), you have to enroll
them. The system should be in the P mode (if not enter F0 6060):
a) Press 1 to open the learning mode*
b) The next free detector position will be displayed on the
keypad.
c) Install batteries into all new detectors step by step to enroll
them (system will automatically offer the next free position)
d) To scroll through sensor positions, press 1 (up) or 7 (down)
e) To enroll a second detector to an occupied position press 5
before you install the detector’s batteries
f) To exit the learning mode press the N key
Wireless keypad (JA-60F) enrolls after you install its battery
while in the learning mode.
Remote control (RC-4x) enrolls after you press and hold both
and buttons while in the learning mode.
Wireless outdoor siren (JA-60A) enrolls after it is powered
while in the learning mode
To enroll the control panel to UC receivers enter 299 on the
keypad while in the P mode
Check individual item manuals for more details
*Learning mode will also open after shortening of the Reset pins
in the control panel.
6. Detectors and controllers testing
a) The system should be in the P mode (if not enter F0 6060)
b) Trigger detectors – their addresses (1=door and 2=PIR) should
be indicated (if the PIR detector does not react, reenter its
testing mode by opening and closing its cover)
c) Press button
on the RC-4x remote control c2 will be
indicated
7. To measure strength of the radio signal
a) While in P mode, press 1 and then using 7 scroll to position 1
b) Press 8 to start measuring
c) Activate the door detector to view its signal strength
d) Using the 1 key, scroll to the next position (2 PIR) and
check its signal strength (if the PIR detector does not react,
reenter its testing mode by opening and closing its cover)
e) Repeat step d) to check all enrolled items. The wireless keypad
(c1) signal is indicated after you trigger its tamper. Remote
control (c2) is indicated after you press it’s button
.
f) Change the location of an item if its signal is lower than 2
g) Return to P mode by pressing the N key
8. Programming of the system
a) System should be in the P mode (if not enter F0 6060)
b) Using the following sequences you can program:
Function Sequence
comments
Your installer
code*
5 xxxx xxxx
6060 factory default
xxxx new code
Exit delay
20x
3=30sec factory def.
Entrance delay
21x
3=30 sec factory def.
Alarm duration
22x
4=4min factory def.
Telephone numbers
entering
7 yy…y F n
yy…y=tel. number
n=memory 1 to 4
7F0Fn will erase memory
n
Alarm voice
message recording
85
then push and hold REC button on the
telephone module and talk to the
microphone – max. 10sec.
Time & date
4 hh mm DD MM YY
Remote Comlink
access code*
07xxxxxxxx
00000000 factory def.
xx..x=new code,8digits
Remote Comlink
access enabling
05x
x=0 disabled
x=6 enabled after 6 rings
See control panel installation manual for more details.
* Must be changed
9. Finishing installation
a) Fill in information on the sticker label and attach it inside the
keypad cover.
b) Switch the system to standby (by pressing the N key)
c) Instruct the user how to operate the system
2

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Jablotron JK-06 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Jablotron JK-06 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,33 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info