555055
1
Verklein
Vergroot
Pagina terug
1/4
Pagina verder
AS-80 access system control unit MKM51600
1
The AS-80 access system control unit
The AS-80 access control system can operate electric devices such as
door locks, gates or security systems. It consists of two parts - a JA-80H
keypad and/or JA-80N RFID card reader (delivered separately) and the
AS-80 control unit with built-in backup power. One or two keypads can
be wired to each control unit (e.g. they can be installed on both sides of
a single door).
A separate control unit with a built-in backup power supply placed in a
protected (indoor) area insures maximum security.
Communication via the cable from the keypad to the control unit is
encrypted with a sophisticated code protocol. This ensures that there is
no other way to operate the device than by entering a valid access code.
The system can handle 120 user codes and RFID cards. An exit button
can be used for easy door opening from inside.
The keypad itself is made of solid plastic, has a backlight for easy
operation and it is suitable for vandal-proof outdoor applications.
Installation
Installation shall only be undertaken by technicians holding a certificate
issued by an authorized distributor.
Up to 2 keypads / readers (JA-80N/H) can be connected to the AS-80
unit. The first keypad must be set as a master and all programming can
only be done using the master keypad. The second (slave) controller
can be a keypad or an RFID reader.
A keypad or reader can be installed outdoors (IP-65).
1. remove the front panel - unscrew the back-housing screw
2. fix the bottom housing onto the desired place (check that the tamper spring
is properly pushed down).
3. connect the keypad’s cable to the control unit’s AS-80 terminals using
8-wire shielded cable, max. length 150 m
4. put the front panel back and fix it using the screw
5. fix the AS-80 unit onto the desired place
6. connect the cable in the AS-80 unit according to the description below
Note, if you change a master keypad, you must set the system up again!
If a second keypad is used then it should be placed at least 50cm from
the master keypad.
Control unit terminal descriptions:
C1, NC1, NO1 relay switch-over contact, max.1.5 A / 24 V
C2, NC2, NO2 relay switch-over contact, max.1.5 A / 24 V
TMP, TMP NC tamper output, max. 0.1 A / 25 V;
IN, COM Exit button switch input
Connection of the keypad / reader to the AS-80 unit
Keypad wire terminal in the control unit
Red + 12V
Blue GND
Green CLK
Brown DTA
Yellow not connected (used for entering setting mode, it
should be isolated after installation)
Pink not connected
Grey, White TMP
LED indicators on the control unit:
Red 1 ON=output relay 1 is triggered
Red 2 ON=output relay 2 is triggered
Green ON=Power on
LED indicators on the keypad:
Status Open System
Red Green - User mode
Green Green - Service mode
Red Green - The relay is switched on (door is
open)
Red Green - Waiting for confirmation by a
flashing code/RFID card
- - Orange Master and Installer codes are
not programmed
First powering-up
1. Set the keypad’s/reader’s operation mode. The first keypad (or if
only one keypad will be used in the system) must be set as a master. A
second keypad/reader can be added to the system at any time and must
be set as a slave.
To open setting mode:
1. Disconnect the power
2. Disconnect the DTA (Brown) and connect it to the yellow wire
3. Restore the power (the keypad starts continuously sounding)
4. Disconnect the Brown and Yellow wires
To set the JA-80H keypad as a master:
press 0 and when the keypad beeps press 4
To set the keypad / reader as a slave:
If you have a JA-80H keypad, press 0 and when the keypad beeps
press 0 again
1

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Jablotron AS-80 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Jablotron AS-80 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,18 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info