28356
32
Verklein
Vergroot
Pagina terug
1/148
Pagina verder
Section 2 Installation
31
Installation Procedure
Installation
When the cable is pulled through the
center of the extension mast, it is
recommended that RTV silicon sealant be
used to seal off the cable slot on the
bottom of the receiver to protect it from
the environment. When the cable is pulled
out through the slot, secure it in position
to protect it against damage due to
vibration. Then seal the slot on the receiver
bottom with the RTV silicon sealant.
Avoid thread damage Grip and turn from the base
Figure 2-5 Installation
Figure 2-6 Appearance
The Wrap or
Tape Cable
The aluminum bottom of the GPS112/DGPS212 are designed so that it can
be installed on the navigation antenna mount unit or on an extension mast
conforming to 1” x 14 NPT standards. The aluminum casing is negative earth, so
a plastic mounting unit should be used to prevent any corrosive activity from
developing. The bottom of the receiver is provided with a slot to allow the
receiver cable to be pulled out to the side. This eliminates the need of pulling the
cable through the center of an extension mast.
When twisting on the receiver be careful not to damage the cable.
Insluate the GPS/DGPS sensor case from ground.
Without insulation, a considerable amount of
current frow from ground to this equipment.
A considerable amount of current may cause
equipment damage.
CAUTION
Seal with
RTV
32

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw JRC Radar1800 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van JRC Radar1800 in de taal/talen: Engels als bijlage per email.

De handleiding is 2,05 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info