28350
286
Verklein
Vergroot
Pagina terug
1/404
Pagina verder
8-54
Adjustment of Inter switch ・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・
[Checking after Installation]
Turn off the ship's mains (switch board) for the radar equipment.
(1) Check that the Interswitch is installed properly after completion of the installation.
In particular, check if the cable is connected correctly and if the shield meshwork of the
cable is grounded properly.
(2) Check that the internal settings in each Display Unit are made adequately.
[Checking the Interswitch Operation]
Turn on the ship's mains (switch board) for the radar equipment.
(1) Checking Interswitch Patterns.
6 interswitch patterns are available for 2-ynits of radar system, and 12 interswitch
patterns are available for 3-units of radar system.
For the checking procedures, refer to the Instruction Manual for Interswitch Kit as
attached hereto.
(2) Checking and adjusting Radar Video
The radar system with the built-in interswitch kit shall be adjusted in the following three
parameters:
Range adjustment (0 NM adjustment)
Bearing adjustment
Rough tuning adjustment
These types of adjustment shall be made for each interswitch pattern as follows:
2-units system ・・・・・・・ No.1 and No.2
3-units system ・・・・・・・ No.1 , No.2 , No.3 and No.12 .
For the method of adjustment, refer to the respective adjustment procedures.
Note: Each adjustment should be performed swiftly after the interswitch is equipped.
These adjustments should be performed on the patterns specified according to the
radar quantity of the system.
If the patterns are switched without adjustments and the radar is used, accurate
information cannot be obtained from the radar.
2-units System
a. Pattern No.1
Adjustment between the Display Unit (right) and the MTR (right). (Adjust by operating
the panel of the Display Unit (right))
Adjustment between the Display Unit (left) and the MTR (left). (Adjust by operating the
panel of the Display Unit (left))
b. Pattern No.2
Adjustment between the Display Unit (right) and the MTR (left). (Adjust by operating the
panel of the Display Unit (right))
Adjustment between the Display Unit (left) and the MTR (right). (Adjust by operating the
panel of the Display Unit (left))
3-units System
a. Pattern No.1
286

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw JRC JMA9933SA bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van JRC JMA9933SA in de taal/talen: Engels als bijlage per email.

De handleiding is 7,69 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info