700474
4
Verklein
Vergroot
Pagina terug
1/37
Pagina verder
6 JL Audio JX360/2 7
ENGLISH
2) Hi-Level Inputs: If your system does not offer
a preamp level signal option, you can connect
speaker level signals directly to the Hi-Level
Inputs connectors using the supplied mating
connectors and wire harnesses. Simply splice
the appropriate left/right and positive/negative
wires to the included harnesses and plug the
harness into the Hi-Level Inputs connectors
on the amplifier. The JX360/2 will attenuate
the high-level signals to make them compatible
with its input stage.
IMPORTANT!
!
Make sure you observe correct polarity in
making the “Hi-Level Input” connections.
Failure to do so will reduce bass and affect
stereo imaging.
The connections for the Hi-Level Inputs” plug wires
are as follows from left to right on the plug:
Channel 1 (Left)
White: Left Positive (+)
White/Black: Left Negative ()
Black: Common Ground (rarely used)*
Channel 2 (Right)
Gray: Right Positive (+)
Gray/Black: Right Negative ()
*The only time you will use the Common Ground
connections is with some older (pre-1980’s) factory
systems or head units that ground their speakers to
chassis ground. To use these connections, ground
the black wires on the plugs to chassis ground and
only connect the Left and Right Positive plug wires
to the factory radio outputs.
IMPORTANT!
!
When the amplifier is bridged, both the Left
and Right inputs must be fed with signal.
Failure to do so will result in significant
audible distortion.
See "Bridging Considerations" section on Page 10
for further information.
INPUT SENSITIVITY CONTROL
The control labeled “Input Sens.” can be used
to match the source units output voltage to the
input stage the amplifier for maximum clean
output. Rotating the control clockwise will result
in higher sensitivity (louder for a given input
voltage). Rotating the control counter-clockwise
will result in lower sensitivity (quieter for a given
input voltage.)
To properly set the amplifier for maximum
clean output, please refer to Appendix A
(page 12) in this manual. After using this
procedure, you can then adjust the “Input
Sens.” level downward if this is required
to achieve the desired system balance.
IMPORTANT!
!
Do not increase any “Input Sens.” setting for
any channel(s) of any amplifier in the system
beyond the maximum level established during
the procedure outlined in Appendix A (page
12). Doing so will result in audible distortion
and possible speaker damage.
TURNON LEAD
The JX360/2 is turned on and off
using a conventional +12V remote turn-
on lead, typically controlled by the
source units remote turn-on output.
+12 VDC Ground Remote
CH. 1
(
L
)
CH. 2
(
R
)
Bridged
The amplifier will turn on when +12V is
present at its “Remote” input and turn off when
+12V is switched off. If a source unit does not
have a dedicated remote turn-on output, the
amplifier’s turn-on lead can be connected to +12V
via a switch that derives power from an ignition-
switched circuit.
18 AWG wire is more than adequate for the
remote turn-on connection. To connect the
remote turn-on wire to the amplifier, strip 1/2-
inch (12 mm) of insulation from the wire and
insert it into the “Remote” receptacle on the
power connector. Tighten the connector down
using the supplied 2.5 mm hex wrench.
INPUT SECTIONS
The JX360/2’s has one pair of stereo
inputs.The input section input section
offers two input connection methods, one
for high-level (speaker level) signals and
one for low-level (preamp level) signals.
1) Low-Level Inputs: A standard left/
right pair of RCA type jacks in the
Amplifier Inputs section is used for
preamp level (low-level) signal input
on the JX360/2. This is the preferred
connection method whenever available.
4

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw JL Audio JX360 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van JL Audio JX360 in de taal/talen: Engels als bijlage per email.

De handleiding is 2,2 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info