701316
4
Verklein
Vergroot
Pagina terug
1/11
Pagina verder
6 JL Audio
7
Make sure you observe correct polarity in
making the “High Level Input” connections.
Failure to do so will reduce bass and affect
stereo imaging.
The connections for the “High Level Inputs plug
wires are as follows from left to right on the plug:
Channels 1&2 (FRONT)
White: Left Positive (+)
White/Black: Left Negative (–)
Black: Common Ground (rarely used)*
Gray: Right Positive (+)
Gray/Black: Right Negative (–)
Channels 3&4 (REAR or SUB)
Green: Left Positive (+)
Green/Black: Left Negative ()
Black: Common Ground (rarely used)*
Purple: Right Positive (+)
Purple/Black: Right Negative (–)
*The only time you will use the Common Ground
connections is with some older (pre-1980s) factory
systems or head units that ground their speakers to
chassis ground. To use these connections, ground
the black wires on the plugs to chassis ground and
only connect the Left and Right Positive plug wires
to the factory radio outputs.
“CH 3&4 Input From” Switch
If you wish to send four discrete channels of
input into the J2-320.4, simply use all four inputs
(Channels 1 & 2 and Channels 3 & 4) and set the
CH 3&4 Input From switch to “3&4”.
HP
|
Off
|
LP
Filter Mode
High-PassLow-Pass
Filter Frequency (Hz)
Filter Frequency (Hz)
Input Sens.
Input Sens.
CH 3&4
Input From
min maxmin max 60 1. 2k
High-Pass
60 1. 2k 40 15 0
Low-Pass
40 15 0
Off +12dB
High-Level InputsHigh-Level Inputs
Bass Boost
HP
|
Off
|
LP
Filter Mode
1&2
|
3&4
Off +12dB
Bass Boost
Channel 3 & 4 Controls
CH 1 (Left) CH 3 (Left)
Protect
Channel 1 & 2 Controls
Power
CH 2 (Right)
LEFT
RIGHT CH 4 (Right)
Pre-Outs Amplifier Inputs
If you wish to feed all four channels by using
only two channels of input, set the “CH 3&4
Input From” switch to1&2” and use only the
inputs to channels 1 & 2.
INPUT SENSITIVITY CONTROLS
The controls labeled “Input Sens.” located in
each Channel Controls section can be used
to match the source unit’s output voltage to the
input stage of each pair of amplifier channels
for maximum clean output. Rotating the control
clockwise will result in higher sensitivity (louder
for a given input voltage). Rotating the control
counter-clockwise will result in lower sensitivity
(quieter for a given input voltage.)
HP
|
Off
|
LP
Filter Mode
High-PassLow-Pass
Filter Frequency (Hz)
Filter Frequency (Hz)
Input Sens.
Input Sens.
CH 3&4
Input From
min maxmin max 60 1. 2k
High-Pass
60 1. 2k 40 15 0
Low-Pass
40 15 0
Off +12dB
High-Level InputsHigh-Level Inputs
Bass Boost
HP
|
Off
|
LP
Filter Mode
1&2
|
3&4
Off +12dB
Bass Boost
Channel 3 & 4 Controls
CH 1 (Left) CH 3 (Left)
Protect
Channel 1 & 2 Controls
Power
CH 2 (Right)
LEFT
RIGHT CH 4 (Right)
Pre-Outs Amplifier Inputs
To properly set the amplifier for maximum
clean output, please refer to Appendix A (page
12) in this manual. After using this procedure,
you can then adjust any or all “Input Sens.
levels downward if this is required to achieve the
desired system balance.
Do not increase any “Input Sens.” setting for
any channel(s) of any amplifier in the system
beyond the maximum level established during
the procedure outlined in Appendix A (page
12). Doing so will result in audible distortion
and possible speaker damage.
TURNON LEAD
The J2-320.4 is turned on and off
using a conventional +12V remote turn-
on lead, typically controlled by the
source unit’s remote turn-on output.
Made in China
CHANNEL 1 (L) CHANNEL 2 (R)
Bridged Bridged
CHANNEL 3 (L) CHANNEL 4 (R) FUSES + VDC
30A30A
Remote
The amplifier will turn on when +12V is
present at its “Remote” input and turn off when
+12V is switched off. If a source unit does not
have a dedicated remote turn-on output, the
amplifier’s turn-on lead can be connected to +12V
via a switch that derives power from an ignition-
switched circuit.
18 AWG wire is more than adequate for
the remote turn-on connection. To connect
the remote turn-on wire to the amplifier, strip
1/2-inch (12 mm) of insulation from the wire
and insert it into the “Remote” receptacle on the
power connector. Tighten the connector down
using a Phillips screwdriver.
INPUT SECTIONS
The J2-320.4’s has two input sections: one for
Channels 1&2 and another for Channels 3&4.
These input sections allows you to send signals to
the amplifier sections through the use of either
two or four inputs. Each input section offers
two input connection methods, one for high-
level (speaker level) signals and one for low-level
(preamp level) signals.
1) Low-Level Inputs: A standard left/
right pair of RCA type jacks in the
Amplifier Inputs” section is used for
preamp level (low-level) signal input
on the J2-320.4. This is the preferred
connection method whenever available.
HP
|
Off
|
LP
Filter Mode
High-PassLow-Pass
Filter Frequency (Hz)
Filter Frequency (Hz)
Input Sens.
Input Sens.
CH 3&4
Input From
min maxmin max 60 1. 2k
High-Pass
60 1. 2k 40 15 0
Low-Pass
40 15 0
Off +12dB
High-Level InputsHigh-Level Inputs
Bass Boost
HP
|
Off
|
LP
Filter Mode
1&2
|
3&4
Off +12dB
Bass Boost
Channel 3 & 4 Controls
CH 1 (Left) CH 3 (Left)
Protect
Channel 1 & 2 Controls
Power
CH 2 (Right)
LEFT
RIGHT CH 4 (Right)
Pre-Outs Amplifier Inputs
2) High-Level Inputs: If your system does
not offer a preamp level signal option, you
can connect speaker level signals directly to
the High-Level Inputs connectors using
the supplied mating connectors and wire
harnesses. Simply splice the appropriate
left/right and positive/negative wires to the
included harnesses and plug the harness into
the High-Level Inputs connectors on the
amplifier. The J2-320.4 will attenuate the high-
level signals to make them compatible with its
input stages.
HP
|
Off
|
LP
Filter Mode
High-PassLow-Pass
Filter Frequency (Hz)
Filter Frequency (Hz)
Input Sens.
Input Sens.
CH 3&4
Input From
min maxmin max 60 1. 2k
High-Pass
60 1. 2k 40 15 0
Low-Pass
40 15 0
Off +12dB
High-Level InputsHigh-Level Inputs
Bass Boost
HP
|
Off
|
LP
Filter Mode
1&2
|
3&4
Off +12dB
Bass Boost
Channel 3 & 4 Controls
CH 1 (Left) CH 3 (Left)
Protect
Channel 1 & 2 Controls
Power
CH 2 (Right)
LEFT
RIGHT CH 4 (Right)
Pre-Outs Amplifier Inputs
4

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw JL Audio J2 320 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van JL Audio J2 320 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,61 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info